Bosch FMM‑100SAT2CKEX User manual

Fire Alarm Systems | FMM‑100SAT2CKEX Explosion‑proof Fire Alarm Manual Station
The FMM‑100SAT2CKEX is a high‑quality, die‑cast metal fire
alarm manual station that is UL and FM Listed for use in
Class I, Division I, Groups B, C, and D; Class II, Division I,
Groups E, F, and G; and Class III (FM Listed only) hazardous
locations. It is also marine and NEMA 4X rated for use in
harsh environments. It complies with Americans with
Disabilities Act (ADA) requirements and meets ADA
standards for wheelchair access when properly installed.
Functions
Operation
When the bar on the front of the manual station is pulled, it
latches open and is easily visible from 50 ft (15 m). Reset
the activation bar by opening the manual station with the
key and placing the activation bar in its normal upright
position. An optional scored acrylic break rod is provided.
Certifications and Approvals
Signal Communications Corp. holds these listings and
approvals:
Region Certification
USA UL UCCM: Boxes, Non-Coded, Marine, UHMV:
Fire Alarm Devices for Use in Hazardous
Locations (Signal Communications)
FM (Signal Communications)
CSFM 7151-1408: 112
NYC/MEA 382‑94‑E, Vol. 5
NEMA Complies with National Equipment Manu-
facturers Association NEMA 4X
ADA Complies with Americans with Disabilities
Act
Installation/Configuration Notes
Compatibility Information
Compatible with all Bosch Security Systems, Inc. Fire Alarm
Control Panels.
Mounting Considerations
The FMM‑100SAT2CKEX Explosion‑proof Manual Station
must be surface mounted on a flat wall. It has two conduit
entries. Any conduit entry that is not used must be plugged.
To comply with ADA standards, the manual station must be
less than 48 in. (1.2 m) above the floor for front wheelchair
access and less than 54 in. (1.3 m) above the floor for side
wheelchair access.
FMM‑100SAT2CKEX Explosion‑proof Fire
Alarm Manual Station
▶Special hazard protection; NEMA 4X and marine
ratings
▶Gold‑plated alarm contacts for corrosion resistance
▶Key lock reset with optional break rod
▶ADA compliant; UL Listed, FM Approved
www.boschsecurity.com

2 | FMM‑100SAT2CKEX Explosion‑proof Fire Alarm Manual Station
Parts Included
Quant. Component
1 Manual station with back box
1 D102 Key (1358 key)
1 Scored acrylic break rod
1 Hardware pack
1 Literature pack
Technical Specifications
Environmental Considerations
Protection Category: IP66
Relative Humidity: 90% at +100°F (+38°C)
Temperature (operating): -40°F to +150°F (-40°C to +66°C)
Mechanical Properties
Color: Red
Dimensions (H x W x D): 6.3125 in. x 3.25 in. x 3.875 in.
(16 cm x 8.3 cm x 9.8 cm)
Material: Die‑cast metal
Weight: 4.8 lb (2.2 kg)
Outputs
Alarm Contacts: Two Form C contacts; each contain one normal-
ly‑open (NO), one normally‑closed (NC), and one
common. Either the NO or the NC with the common
can be wired to the terminal block. All contacts rated
for 1 A at 30 VDC or 120 VAC
Ordering Information
FMM‑100SAT2CKEX Explosion‑proof Fire
Alarm Manual Station
High‑quality, metal manual fire station in red
FMM-100SAT2CKE
X
Accessories
D102 Replacement Key
Replacement key (#1358) for the D101 lock.
D102
FMM‑100GR Scored Acrylic Break Rods
Scored acrylic rods (12 per package)
FMM-100GR
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: [phone]
[email protected]
www.boschsecurity.com
Asia-Pacific:
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
Represented by
© Bosch Security Systems Inc. 2010 | Data subject to change without notice
T2363729163 | Cur: en-US, V11, 4 Jul 2010