How to operate the SDC-16
1. When switching on the power supply, the LED window will display the start DMX channel
address. It can be "A001". If there are no character and number display, check the power
whether it's correctly connected.
2. The default start address for controlling the DMX channels is channel 1. To adjust the initial
start address, you can press the Up key to increase it by 1. When holding the Up key for 1
second, the start address will increase rapidly from the initial value to the desired value. You
can also press the Down key to decrease the present value by 1. When holding the Down key
for 1 second, the present value will decrease rapidly to the desired value.
.
NOTE: Whenever you want to adjust the start address, press Up key or Down key to shift the
start address setting mode. In this case, you may change the start address temporarily. You
can control the 16 continual DMX channels from the beginning of the starting address. The start
address must be 1 ~ 512. And the overflowing channels will not be proceeded.
3. Pushing the channel fader, one of the 16 channels faders, can allow you to adjust the relative
channel value. The LED will display the value temporarily with the default mode of decimal
( 0 ~ 255 ) when sliding the fader. For percent display mode, you can press the MODE key.
In this case, the indicating LED of right lower corner will be out in the display window and
the indicating LED of right higher corner will be lit up.
16
12345678910
11 12 13 14 15
MASTER
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
MODE UP DOWN
SDC-16
16CH Simple DMX Controller
0-255
%
Fader
Mode
Up
Down
Master
Fader
After you have set the 16 channels values, waiting about 10 seconds, the LED window will
automatically show the start address.
