Botex SDC-6 User manual

Manual
Controller DMX
SDC-6

2 / 8
Table of content
1. Safety instructions ........................................................................................................................... 3
1.1. FOR SAFE AND EFFICIENT OPERATION............................................................................ 3
2. Product view.................................................................................................................................... 5
3. Technical Data................................................................................................................................. 6

3 / 8
1. Safety instructions
•Read the safety instructions and also this manual carefully.
•Keep the manual.
•Observe all red flags.
•Observe the manual.
•To prevent fire or electric shocks, protect the device against rain and
humidity
•Pull the plug before opening the housing.
•To prevent an electric shock you should not remove the cover.
•Do not operate the device in the near of water.
•Use only a dry cloth for cleaning.
1.1.FOR SAFE AND EFFICIENT OPERATION
Be careful with heat and extreme temperature
Avoid exposing it to direct rays of the sun or near a heating appliance.
Not put it in a temperature bellow 40°F /5°C, or exceeding 100°F /30°C.
To avoid placing on un-stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust, or a wet soft cloth for stubborn dirt. Pull the plug before
cleaning.
If out of work, contact sales agency immediately
Any troubles arose, remove the power plug soon, and contact with an engineer for repairing, do not
open the cabinet by yourself, it might result a danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure to hold the plug. When not
using the device for an extended period of time, be sure to disconnect the plug from the receptacle.
Safety
Do not remove the grounding. It is for your safety. If you remove the grounding it can cause electric
shocks.

4 / 8
Accessory
Please use only the accessory which is set by the manufacturer.
Important
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems. Make sure the electrical connection is carried out
by qualified personnel. All electrical and mechanical connections have to be carried out according to
the European safety standards.

5 / 8
2. Product view
1. Power indicator
When the unit is powered on, this LED will be lit.
2. Channel faders 1-6
These six faders provide direct control over the corresponding dimmers, and thus the intensity for
any connected lights.
3. Master fader
The master fader can adjust the values of 1-6 channels and it provides total control towards
overall DMX output.
4. DMX output
This is the output for DMX signal.
5. Power switch
6. DC input
7. Battery compartment for 9V battery

6 / 8
3. Technical Data
Power input
DC 9V, 100mA Min
DMX output
3-pin female DMX connector
Battery (not included)
PP3, 9V
Dimensions
173x153x55mm
Weight
0.6kg

7 / 8

8 / 8
Importer:
B & K Braun GmbH
Industriestraße 1
D-76307 Karlsbad
www.bkbraun.com
[e-mail]