Breville EM3 Quick guide

Wizz Mix
INSTRUCTIONS FOR USE
AND RECIPE BOOK
odel E 3

Page
Breville Recommends Safety First 4
Know your Breville Wizz ix 5
Assembly and Operating Your Breville Wizz ix 6
Care and Cleaning 8
ixing Guide 9
Recipes 10
Eggs 10
Batters 11
scones 13
Tea cakes 15
Cakes 17
CONTENTS
2

Wizz Mix
Congratulations
on your purchase of your new Breville Wizz ix

4
••To protect against electric shock do not
immerse cord, plug or mixer body in
water or any other liquid.
••Handle your mixer and attachments with
care. Never place your fingers inside a
mixing bowl or near beaters during use.
••Keep hands, hair, clothing, as well as
spatulas and other utensils away from
moving beaters during operation.
••Ensure the motor and beaters have
completely stopped before setting the unit
down on the benchtop or disassembling.
••Do not place hands in the mixing bowl
unless the unit is disconnected from the
power outlet. Disconnect the mixer from
the power outlet before removing beaters.
••Use only the beaters supplied with
this mixer.
••Always remove the beaters from the
mixer before cleaning.
••Always switch the appliance off and then
switch off at the power outlet before
unplugging the appliance after use and
before attempting to move the appliance,
before putting on or taking off parts and
before cleaning.
••The appliance is not intended for use by
young children or infirm persons without
supervision.
••Do not leave the appliance unattended
when in use.
••Young children should be supervised
to ensure that they do not play with
the appliance.
••Regularly inspect the supply cord, plug
and actual appliance for any damage. If
found damaged in any way, immediately
cease use of the appliance and return the
entire appliance to the nearest authorised
Breville service centre for examination,
replacement or repair.
••The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
••Do not let the cord hang over the edge of
a table or counter, touch hot surfaces or
become knotted.
••Do not place this appliance on or near a
hot gas or electric burner, or where it
could touch a heated oven.
••This appliance is for household use only.
Do not use this appliance for anything
other than its intended purpose. Do not
use outdoors.
BREVILLE RECOMMENDS SAFETY FIRST
We at Breville are very safety conscious. We design and manufacture consumer products with
the safety of you, our valued customer foremost in mind. In addition, we ask that you exercise
a degree of care when using any electrical appliance and adhere to the following precautions:
IMPORTANT SAFEGUARDS

5
KNOW YOUR BREVILLE WIZZ MIX
ixer motor body
Turbo button for extra burst of power
5 speed selector switch plus Pulse
Eject button for release of beaters
320 watts of power
Beater sockets
Steel mixing beaters
Steel dough hooks

ATTACHING THE BEATERS
1. Insert each beater shaft into the left and
right beater sockets underneath the
mixer body (see Figure 1).
2. Insert the beaters by pushing the shaft of
the socket, turning slightly if required
until they lock into place.
3. Ensure that the speed selector switch is
set to the ‘OFF’ (O) position. Select a
mixing bowl large enough to
accommodate the beaters, as a bowl that
is too small will damage the beaters.
4. Add ingredients to the mixing bowl as per
the recipe or your requirements.
5. Plug the cord into a 230/240v power outlet
and turn power ‘ON’.
6. Place the beaters into the ingredients
inside the mixing bowl. To commence
mixing, move the speed selector switch to
the right to the required speed.
Always begin mixing on a lower speed
setting to prevent splattering, increasing
to the desired speed for the mixing task.
The speed setting can be adjusted during
operation by moving the switch from left
to right.
7. ove the mixer in a slight circular action
during mixing to allow the beaters to
efficiently mix the ingredients. Stop the
mixer now and then, using a plastic
spatula, scrape down the sides of the
mixing bowl, then continue mixing.
6
ASSEMBLY AND OPERATION OF YOUR BREVILLE WIZZ MIX
Always turn the Wizz Mix
off if you need to scrape
down the bowl during use.
AVOID CONTACT WITH BEATERS DURING OPERATION. KEEP HANDS,
HAIR, CLOTHING, SPATULAS AND OTHER UTENSILS AWAY FROM THE
BEATERS TO PREVENT INJURY OR DAMAGE TO THE WIZZ MIX.
ENSURE THE MIXER IS SWITCHED OFF AND UNPLUGGED FROM THE
POWER OUTLET BEFORE ATTACHING THE BEATERS TO THE MIXER.
Fig. 1

8. When mixing is complete move the speed
selector switch back to the ‘OFF’ (O)
position. Turn the power off at the power
outlet and unplug cord.
9. Remove the beaters by pressing the eject
button while grasping the beater shafts.
The beaters will be released
automatically. DO NOT try to pull the
beaters out of the sockets.
TURBO BOOST FUNCTION
Pressing the Turbo Boost button while
mixing provides an extra burst of power,
overriding the speed setting being used.
Press the Turbo Boost button and hold
it down for no more than 30 seconds to
avoid overheating. After the Turbo Boost
has been used, always turn the mixer
off and allow it to cool down for a few
minutes before using again.
ASSEMBLY AND OPERATION cont’d
7
Avoid allowing the beaters
to hit against the side of the
mixing bowl while the
mixer is operating as this
will result in damage to
the beaters.

CARE AND CLEANING
8
BEFORE FIRST USE
Before using your Breville Wizz ix for
the first time, wash the beaters in warm
soapy water with a soft cloth. Rinse and
dry thoroughly. They may be washed in
a dishwasher.
CLEANING AFTER USE
1. Always ensure that the speed selector
switch is in the ‘OFF’ (O) position and that
the power is turned off at the power
outlet. Then remove the plug from
the power outlet.
2. Press the eject button and remove
the beaters.
3. Use a rubber spatula to clean off the
beaters. Then wash the beaters in warm
soapy water with a soft cloth. Rinse and
dry thoroughly. They may also be washed
in a dishwasher. Do not allow the beaters
to soak in water for an extended period of
time, as this may lead to the metal finish
being damaged.
4. Wipe the mixer body with a damp cloth
and dry. Polish with a soft dry cloth.
5. Wipe any excess food particles from the
power cord.
STORAGE
Always unplug the Wizz ix from the power
outlet before storage. Wrap the power cord
around the mixer body. Rest the mixer body
on its heal. Safely store the beaters where
they won’t be damaged.
The packing carton supplied with this
product is an ideal storage box.
NEVER IMMERSE THE MIXER, POWER CORD OR PLUG IN WATER OR ANY
OTHER LI UID.
When first using your Wizz
Mix, you may notice an
odour from the motor. This
is normal and will dissipate
as the motor is run in.
Do not use abrasive
scouring pads or cleaners
when cleaning the beaters
as these may scratch the
beater surface. Also ensure
that the beaters are not
soaked in water for
extended periods of time ie.
For several hours or
overnight, as this may
damage the metal finish.

SPEED MIXING TASK FOR
SETTING
1Folding in / Light blending Scones, pastry, quick tea cakes, bread dough
2Folding in / Light blending Biscuit dough
3Light ixing Sauces, puddings, custards,
Icings, packet mixes
4Creaming / Beating Butter and sugar, cream cheese,
heavy batters
5Whipping / Aerating Beating cream, egg whites /
meringues, marshmallow
MEASURING UP
Metric Weighing cales
For greatest accuracy and best results, a set
of metric weighing scales should
be used. Tare (zero) the scales with the
container in position then spoon
ingredients in until desired weight is
achieved. In general, water weighs the
same in grams as it measures in millilitres;
therefore greater accuracy is obtained
by weighing.
Metric Measuring Cups and poons
When using the graduated ETRIC
measuring cups, it is important to spoon or
scoop the dry ingredients loosely into the
required cup. Do not tap the cup on
the bench, or pack the ingredients into the
cup UNLESS otherwise directed.
Level top of cup with knife. When using
graduated metric measuring spoons,
level top of spoon with a straight edged knife
or spatula.
DO NOT USE TABLEWARE
SPOONS OR CUPS.
Metric Liquid Measuring Jugs
When measuring liquids use a graduated
metric measuring cup. Place jug on a
flat surface, check for accuracy at eye level.
MIXING GUIDE
9
ALWAYS USE A STANDARD
METRIC LI UID
MEASURING JUG.

SOUFFLE FRENCH OMELETTE
WITH HAM & HERBED CHEESE
Serves 4
2 tablespoons butter
120g sliced ham, thinly sliced
2 tablespoons finely snipped chives
1 tablespoon chopped parsley
1 medium tomato
4 eggs, separated
2 tablespoons milk
1 teaspoon mild English mustard
1⁄4teaspoon salt
1⁄2cup grated tasty cheese
1. Melt butter in frypan on medium heat.
2. aute the ham, chives, parsley and tomato
for 2 minutes. Remove and put aside.
3. Combine egg yolks, milk, mustard and
salt in small bowl.
4. Beat egg yolk mixture on speed 2
until combined.
5. eparately beat egg whites on speed 5
until soft peaks form and whites are light
and fluffy.
6. Fold egg whites through combined egg
yolk mixture; lightly heat frypan to a
medium heat.
7. Pour egg mixture evenly into frypan and
cook until omelette puffs up and base of
omelette is golden and crisp.
8. prinkle with sauteed filling. Turn
omelette in half and sprinkle with
grated cheese.
lice into four large slices and serve
with salad.
FLUFFY SMOKED SALMON
CREAMED EGGS
Serves 2
4 eggs
1⁄2cup thickened cream
freshly ground black pepper
2 tablespoons butter
150g smoked salmon, roughly chopped
2 tablespoons finely snipped chives
1. Place eggs and cream into a small bowl,
beat on speed 2 until light and fluffy.
eason with pepper.
2. Melt butter in frypan. Pour eggs into
hot pan, stir until mixture has
thickened slightly.
3. tir through chopped salmon; cover with
lid until eggs are firm, light and fluffy.
prinkle with chives and serve.
EGGS
10