Britax Click & Go User manual

www.britax.com.au
Customer Service: 1300 303 330
AGILE CLICK & GO RECEIVER
Receiver for an Agile Stroller to accommodate
a Britax Safe-n-Sound Unity Infant Carrier*
where Britax Stroller Click & Go Adapter* is fitted.
RRL
*Receivers only fit Series No. 40/A/2010 Unity Infant Carrier models.
Britax Stroller Click & Go Adaptor sold separately.
Agile Receivers fit onto both sides of the Agile Stroller. Take one
Agile Receiver at a time and insert into the stroller hinge as shown.
Push on the receiver until you hear a ‘click’ which indicates the
receiver has locked in. Pull up on each receiver to check they have
fully engaged.
1
AGILE CLICK & GO RECEIVERS ARE MARKED
‘L’ (LEFT) AND ‘R’ (RIGHT) FOR CORRECT FITTING
1
HOW TO FIT
a. Squeeze both carry handle release latches to release the
handle and rotate upwards.
b. Rotate the handle upwards towards the “carry position” to
unlock the carrier from the stroller.
c. Once handle is locked in the “carry position” lift and remove
the Infant Carrier away from the stroller frame.
5
5a 5c
TO RELEASE THE INFANT CARRIER FROM
STROLLER
IMPORTANT: These Instructions are for installing and
removing the Infant Carrier on the stroller only. Refer to the
Infant Carrier Instruction book regarding placing and
securing your baby in the Infant Carrier.
HOW TO REMOVE THE AGILE CLICK & GO
RECEIVER
To remove the Agile Click & Go Recievers, press the grey button
on the inside of the receiver and pull the receiver up out of the
stroller hinge.
6
Art No. 4001571

Fit the Britax Stroller Click & Go Adaptors to the Safe-n-Sound
Unity Infant Carrier.
Please refer to Britax Stroller Click & Go Adaptors Instructions for
the correct installation of the adaptors.
2
2
HOW TO FIT
With the Infant Carrier handle in the “carry position”, place the
Britax Stroller Click & Go Adaptor on each side directly over the
Agile Click & Go Receivers and push down.
3
TO INSTALL THE INFANT CARRIER INTO
STROLLER
3
IMPORTANT: These Instructions are for installing and
removing the Infant Carrier on the stroller only. For Installing
of the Infant Carrier in the car please follow the Instruction
book included with the Infant carrier.
To secure the Carrier to the stroller rotate the handle to the “non
rocking position”, To do this:
a. Squeeze the carry handle release latch on each side of the
handle and rotate to the “rocking position”
b. Squeeze the latch again and start to rotate the handle then
remove both hands from the latches and use one hand at
the top of the handle to rotate down further until the handle
latches in the “non-rocking position”. The carrier is now
locked to the stroller. Pull up on carrier to ensure it is locked
in position.
4
4
4a
Non-rocking
Position
Rocking
Position
4b
4a
4b
Push down until it clicks into place.
Carry
Position