Britax Marathon E9L06 Guide

1 Cut old adjuster strap.
3 From rear of seat, pull straps up to
remove yoke from behind belt guard,
then slide both shoulder straps off metal
yoke.
4 Discard old adjuster strap.
2 Completely loosen shoulder straps by
lifting the adjuster lever while pulling
the harness straps forward.
WIZARD ONLY: Fully raise headrest
before proceeding.
5 Attach shoulder straps to yoke on
new adjuster strap.
IMPORTANT: Attachment must be
exactly as shown in photo for correct
alignment. White tab must be toward seat.
6 Drop loose end of adjuster strap
between black belt guide and rear of
seat.
7 Route loose end of adjuster strap over
base to the front.
Adjuster Strap
Replacement Instructions
for Marathon™& Wizard™
Items required:
-Scissors
- New adjuster strap
Overview: Front Overview: Rear

13 Continue to lift adjuster lever and
use paper tab to assist pulling strap
completely through adjuster.
14 Verify that adjuster strap is routed
properly, as shown above.
15 Verify that shoulder straps and the
adjuster strap are not twisted.
16 Cut paper tab, then remove and
discard.
11 Loop strap over, toward the front of
the seat.
12 Lift adjuster lever and thread
adjuster strap between metal bar and
adjuster lever until paper tab is
accessible from the front of the adjuster.
10 Pull strap through completely.
Britax Child Safety, Inc.
13501 South Ridge Drive
Charlotte, NC 28273
Consumer Services: 1-800-683-2045
For further information visit BritaxUSA.com
© 2004 Britax®Child Safety, Inc.
P247100 - R1:08/04
9 From the bottom of the seat, thread
adjuster strap through slot behind
adjuster to the top of the seat.
NOTE: To access bottom of adjuster area, lay
seat on its back, with the base toward you.
8 Pull strap over base to the front of the
restraint.