Brother TN3030 User manual

Replacing Brother TN3030/ 3060 Toner Cartridge
www.ImageMaker.com.sg Page 1
CAUTION
We recommend that you place the drum unit assembly on a piece of disposable paper or cloth in
case you accidentally spill or scatter toner.
To prevent damage to the printer from static electricity, do not touch the electrodes shown bellow.
CAUTION
Handle the toner cartridge carefully. If toner scatters on your hands or clothes, immediately wash it
off with cold water.
NOTE
Be sure to seal up the drum unit tightly in a bag so that toner powder does not spill out of the unit.
1. Press the cover release button and then open the
front cover of the printer.
2. Pull out the drum unit assembly. (drum unit with
toner cartridge.
3. Push down the blue lock lever and take the toner
cartridge out of the drum unit.

Replacing Brother TN3030/ 3060 Toner Cartridge
www.ImageMaker.com.sg Page 2
4. Unpack the new toner cartridge. Hold the cartridge level with both hands and gently rock it from
side to side five or six times to spread the toner evenly inside the cartridge.
6. Put the new toner cartridge firmly into the drum unit your hear it lock into place. If you put it in
properly, the lock lever will lift automatically.
CAUTION
Wait to unpack the toner cartridge until immediately
before you put it in the printer. If toner cartridges
are left unpacked for a long time the toner life will be
shortened.
Wait to unpack a drum unit until immediately before
you put it in the printer. Exposure to direct sunlight
or room light may damage the drum unit.
CAUTION
Put the toner cartridge in the drum unit immediately after you have removed the protective cover. Do
not touch the shaded parts shown in bellow to prevent any degradation to the print quality.
5.
Pu
ll off the protective cover.

Replacing Brother TN3030/ 3060 Toner Cartridge
www.ImageMaker.com.sg Page 3
CAUTION
Make sure you insert the toner cartridge properly or it may separate from the drum unit.
7. Clean the primary corona wire inside the drum unit by gently sliding the blue tab from right to left
and left to right several times. Return the tab to the home position (▲) before you put the drum
unit back in the printer. If you do not, printed pages may have a vertical stripe.
8. Put the drum unit assembly back in the printer. Close the front cover of the printer.