Setup Complete
7Connect your computer or mobile device Connect your Brother machine and computer/mobile device to the
same network.
Install Brother software to use your machine. Visit one of the following websites:
For Computers:
For Windows only, CD installation is also
available.
For Mobile Devices:
Follow the on-screen instructions.
For Wired Network Connection* and USB Connection:
Use the correct port (based on the cable you are using)
inside the machine, as shown.
Install the Brother iPrint&Scan
application.
1. Press OK to set the date and time.
2. Press aor bto select the number, and then press
OK to set the date and time.
5Set the date and time
When the machine has finished the initial cleaning process, follow the steps on the LCD to configure
the machine settings.
• Check the print quality DCP-T820DW:
• Configure the paper tray settings
6Machine settings
None A Few About Half Many
*DCP-T820DW
When finished, remove the bottle,
pointing the nozzle upward so the ink
does not spill.
Replace the ink tank cap. Repeat step
4for the other ink tanks, and then
close the ink tank cover.
setup.brother.com
1
brother.com/apps
Find the SSID (Network Name) and Network Key
(Password) on your wireless access point/router.
1. Go to your machine and press WiFi.
2. Press OK to select [Find
Network].
The [WLAN Enable?] message
appears on the LCD.
3. Press ato select [On].
Select the SSID (Network Name) for your access point/
router and enter the Network Key (Password).
To enter the Network Key, hold down or repeatedly press a
or bto select a character from the list below:
abcdefghijklmnopqrstuvwxyzABCDEFGHIJKLMNOPQR
STUVWXYZ0123456789(space)!”#$%&’()*+,-./:;<=>?@
[\]^_`{|}~
When the wireless setup is successful, the LCD displays
[Connected].
If you cannot find this information, ask your
network administrator or wireless access point/
router manufacturer.
Manual wireless setup (if needed)
SSID: XXXXXXX
Network Key: XXXX
