Buchi S-300 User manual

11594371A en
MiniSprayDryer S-300 in open suction mode
06.2022
BÜCHI Labortechnik AG
Meierseggstrasse 40
Postfach
CH-9230 Flawil 1
E-Mail: [email protected]
Reading and following the instructions in this document does not replace reading and
following the instructions in the operation manual.
The following instruments are necessary for the open pressure mode:
MiniSprayDryer S-300
Dehumidifier S-396 (option)
2
3
4
5
1
6
7
89
10
Assembling instruction:
uAttach the tubing pieces.
uClose the easy clamp.
uTighten the nut.
1
2
2
3
Necessary installation:
uInstall the gas tube inside the connection marked Inlet.
uInstall the gas tube to the heater.
uInstall the tube to the filter. See operation manual "MiniSprayDryer S-300"
uInstall the gas tube to the connection marked Filter on the spray dryer.
uInstall the gas tube inside the connection marked Filter.
uInstall the gas tube to the aspirator inlet connection marked.
uInstall the gas tube to the aspirator outlet connection marked.
MiniSprayDryer S-300 in open suction mode
Installation Manual

2/2 Installation Manual MiniSprayDryer S-300 in open suction mode
uInstall the gas tube inside the connection marked Outlet.
Installation option:
Precondition:
RThe dehumidifier is prepared. See operation manual "Dehumidifier B-396"
uInstall the gas tube to the dehumidifier connection marked Outlet.
uInstall the gas tube to the connection marked Inlet.
BÜCHI Labortechnik AG