Buckingham 2139 User manual

Foot Strap
Chafe
Split Ring
1” Buckle
Short Rivets
Tall Rivets
Buckle Strap
1” Loop
Strap Retainer
Burrs
PN 2139 –FOOT STRAPS FOR RING TYPE CLIMBERS
ASSEMBLY & ATTACHMENT INSTRUCTIONS
Overview of parts (shown is only ½of the supplied materials, or enough to make 1 strap, for 1 side):
1) Insert 1 tall rivet through 2) Place buckle strap over rivet 3) Place buckle on buckle strap
chafe as shown. as shown. with tongue through slot.
4) Fold buckle strap over rivet 5) Place a copper burr over rivet. 6) Seat the burr onto the rivet shaft.
and into next hole. (Use tool/method appropriate to seat burr)
7) Correctly seated burr shown 8) Do not seat burr too hard 9) Carefully peen the rivet tip until
below. such that it tears the back flattened over the burr.
side of the chafe leather. (Use tool/method appropriate to peen rivet)
2139.doc PN 230307
Rev. 8-19-16
Optional: Burr Seating & Rivet Flattening Tool (not included)

10) Place 1” loop onto buckle strap 11) Place split ring onto buckle 12) Fold remaining buckle strap under
end, being sure the “split” is on strap. itself. 1” loop towards the right, split
the BOTTOM, facing the chafe. ring to left of the holes as shown.
13) Insert a tall rivet through the chafe & 2 buckle 14) Place foot strap through ring as shown. Insert 2
strap holes. Attach a burr, seat, & peen same as short rivets and fold strap over onto rivets as shown.
shown in steps 5 through 9. Place and seat a burr onto first rivet.
15) Place burr & seat onto second rivet. 16) Peen rivet tips (Step 9). 17) Completed assembly.
18) Over all view 19) Assemble strap onto climber using split ring
(buckle end points toward toe).
20) Repeat these steps for the opposite side.
BUCKINGHAM MFG. CO.
BINGHAMTON, NY
1-800-937-2825
Web site –www.buckinghammfg.com
Information contained in these written instructions supersedes all other information (written, audio, video etc.) produced by
Buckingham Mfg. prior to the revision date of this document.
2139.doc PN 230307
Rev. 8-19-16
Split of
loop