Buckingham 60007 User manual

INSTRUCTIONS / WARNINGS
P/N 60007 Buck Tool Tether
ATTACHMENT
1. Using a girth hitch, attach the Loop End of the tether to a Body Belt Accessory Ring (Fig. 1).
Body Belt Accessory Ring
Body Belt
Accessory Attachment
(snap or carabiner)
2. Using the Cinch Loop and the Snap End of the tether, make a girth hitch around the handle
of the tool as shown in Fig. 2, 3, & 4.
3. The brass snap of the tether may be used for attachment to the body belt accessory snap,
or accessory carabiner, when not using or transporting tools (Fig.1).
60007.DOC (Rev. 8/18/16)
PN 230376
OVER
Fig. 1
Fig. 3
Fig. 4
Fig. 2

WARNINGS
THIS PRODUCT IS NOT TO BE USED FOR PERSONAL FALL PROTECTION.
For proper function, this product must not be used with a tool weighing more than 15 lbs.
(4.8 kg).
Dropping your tools is not recommended as it may cause damage to the unit.
Remove unit from service, destroy,and discard if tool is dropped.
Inspect for wear prior to each use.
Do not use for human support.
Do not use around moving or rotating equipment.
Tether extends to a length of 5 1/2' (1.7 m). Rig to avoid contact with objects below.
Ensure girth hitch remains snug while in use.
Always attach the tether to your body belt accessory ring or accessory snap / carabiner. Never
attach the tether to a work positioning or fall arrest D-ring.
Do not attach tether back onto itself.
Do not tie knots in tether.
Do not rig so that the tether may interfere with or depress the trigger mechanism of the tool.
NOTE: Ensure proper fit / size of product before use. This product can not be returned unless it is in
new / unused condition.
BUCKINGHAM MFG. CO., INC.
BINGHAMTON, NY
1-800-937-2825
www.buckinghammfg.com
Information contained in these written instructions supersedes all other information (written, audio, video etc.) produced by
Buckingham Mfg. prior to the revision date of this document.
60007.DOC (Rev. 8/18/16)
PN 230376