Buffalo WCR-G54 User instructions

WCR-G54 Router Access Point Settings
1. At the back of router, set the switch to “Router mode
2. Power on Buffalo Router, and wait for 2 minutes.
The “Power , “Router and “Wireless indicators will be ON, and other
indicators will be OFF.
3. To reset the router, please insert “RESET hole by a paper clip for about
10 seconds, and wait for 2 minutes.
The “Power , “Router and “Wireless indicators will be ON, and other
indicators will be OFF.
4. Please use network cable to connect “LAN1 port on the ROUTER to
the Ethernet adapter on your PC. Make sure indicator besides “LAN1 is
ON.
Last Update 24April 2008 WCR-G54 Access Point Page 1

WCR-G54 Router Access Point Settings
Buffalo Router Wireless Settings:
Launch Web Browser, enter http://192 168 11 1 in address bar and then press
Enter. Then type username as “root”, default no password.
1. Click “Wireless Config -> Click “Basic(11g). Under SSID, the default
“SSID (wireless network signal name) of router is set to “Use
Airstation's MAC Address (XXXXXXXXXXXX) . If you want to use
another name as SSID, please choose “Use , and input a new name on
the field behind.(Remark: Cannot exceed 32 characters, and leaving
blank in between is not recommended),
Under Wireless Channel, please fix a wireless channel for your router.
(Using “Auto Channel is not recommended). Please try channel 1, 6,
11, or other channels until the wireless network is stable. Please click
“Apply to save settings.
Please click “Apply again, and wait for 2 minute to complete settings.
5. To secure your wireless network, please click “Security(11g) .
Under “Wireless Encryption ,
- Choose “WEP ,
- Set “WEP Encryption Key to Character Input: 13 characters
(WEP128) .
- Behind “1, input a 13 characters wireless encryption key to secure the
wireless network.
- Click “Apply button to save settings.
Last Update 24April 2008 WCR-G54 Access Point Page 2

WCR-G54 Router Access Point Settings
Please click “Apply again, and wait for 2 minute to complete settings. Connect Access Point to the existing network
1. Remove network cable connecting from your computer to router
2. At the back of router, set the switch to “Bridge mode
3. The “Router indicator will be OFF.
4. Connect “LAN 1 port of Buffalo router to your existing network.
Settings Complete.
Last Update 24April 2008 WCR-G54 Access Point Page 3