Bullhorn RM5 I/O4 User manual










RM5I/O4UserGuide
Dra













Getting Started
ThisguideprovideoverviewofRM5I/O4unit.

RM5 I/O4 Overview
TheRM5I/O4unitisusedtomonitorupto4analogvoltageand2digitalinputs.RM5I/O4alsoincludes
arelaycontroloutputvoltageandinterfaceportstodaisychainaddionalRM5I/O4units.RM5I/O4is
powerbyexternal12Vdcvoltagesource.DomeStatusLEDwillilluminatewhenpowerisappliedtoRM5
I/O4unit.




BluetoothinterfaceisacvatedbyplacingmagnetnearrightsideofRM5I/O4units.BlueLEDwill
illuminatetoindicateBluetoothisacve.







FCCStatementsandWarning:

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
In order to comply with FCC RF Exposure requirements, this device must be installed to
provide at least 20cm separation from the human body at all times.
Industry Canada Statements and Warnings:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
“L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1. L’appareil ne doit pas produire de brouillage ;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.”
In order to comply with ISED RF Exposure requirements, this device must be installed to
provide at least 20cm separation from the human body at all times.
“Afin de se conformer aux exigences d'exposition RF ISED, cet appareil doit être installé
pour fournir au moins 20cm de séparation du corps humain en tout temps.