Bunn AutoPOD Instruction Manual

BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: [phone] FAX: [phone]
41816.0000B 04/09 ©2009 Bunn-O-Matic Corporation
AutoPOD
Instructions for Installing
Retrofit Tank Kit #41021.1100
KIT CONTENTS
1 42041.0000 Hot Water Tank
1 41022.0000 Brew Tank
2 28891.0009 Temp probes
2 36629.0003 Braided tubes
2 12422.0000 Clamps, SNP-6 (Lower)
1 12422.0006 Clamp, SNP-8 (HW inlet)
2 12422.0011 Clamps, SNP-4 (Upper)
1 41816.0000 Instructions
INSTRUCTIONS
Refer to illustrations.
1. Follow tank draining procedure in Operating Manual.
2. Remove rear access panel.
3. Remove 3 screws securing board mounting bracket to frame. Pivot board assembly to gain access to plumbing
under brew tank.
4. Disconnect hoses & connectors from both tanks.
5. Remove the screws securing the tank retaining straps & remove tanks.
6. Cut the steel bands from old tanks & remove limit thermostats. Install them under clips of new tanks &
reconnect harnesses. FIG 2A & B
7. Install new tank assemblies & retaining straps.
8. Install level probe in Hot Water tank.
INTRODUCTION
WARNING - The brewer must be disconnected from the power source until installation is completed. Allow
brewer to cool.
This instruction covers the installation of new style tanks into early models.
WARNING: Software must be at version .17 or higher to operate new style temperature probes.
CONTINUED

NEW STYLE TANKS
FIG 1
9. Connect inlet & outlet hoses to both tanks. NOTE: New HW tank has larger inlet barb fitting than old HW tank.
FIG 2. Discard short hose that was used as a reducer on old tank. Use the included SNP-8 clamp when installing
inlet hose on new HW tank.
10. Install new temp probes & braided tubes as shown above. Install SNP-6 clamps at bottom of braided tubes, and
SNP-4 clamps at top of braided tubes.
Hot Water Tank
Brew Tank
Limit thermostat clips
New thermistors
mounted through top
CONTINUED

FIG 2A
Cut band, reuse limit
Reuse level probe
Discard
Discard
FIG 2B
CONTINUED
OLD STYLE HOT
WATER TANK
SHOWN
NEW STYLE
BREW TANK
SHOWN

BREW TANK THERMISTOR
HOT WATER TANK THERMISTOR
FIG 3
11. Reinstall control board/bracket assembly. Connect temp probe harness to control board. FIG 3
12. Replace the rear access panel. Place large cup under brew chamber.
13. NOTE A: If using same control board, use the initial tank fill procedure; press & hold “OPEN/CLOSE” & “HOT
WATER” buttons while connecting to power source. FIG 4
NOTE B: If installing new control board, connect to power source & start a brew cycle to fill tanks.
14. Discard the old tank assemblies.
FIG 4