BUNNING G8SAFE User manual

IMPORTANT
Adjust clockwise only Insert tool and
push to release
INCREASE TENSION RELEASE TENSION
ADJUSTMENT DIAGRAMS
Pic A: hinges must be
spaced minimum
900mm from top to top
Pic A Pic B Pic C
Pic D Pic E
G8SAFE
G8
SAFE
.com.au
CREATING WAVES FOR POOL SAFETY
POOL SAFE
GATE KIT
INSTALLATION
TRUST IN QUALITY: The Pool Safe Gate Kit has
been designed for optimum safety & ease of installation
G8SAFE SAFETY CHECKLIST
✔Hinges are tension adjustable and self closing
✔Latch cannot be locked in the open position
✔Patented self-latching mechanism, latches
without any pressure
✔ Latch cannot be prised or shaken open
✔Tested to AS1926.1-2012
✔Superior Quality, hinges hold 45kg
✔ Hinge safety cone to prevent climbing
HINGES
1. Mark and fi x hinges to gate. Distance between top of hinges must
be minimum of 900mm (Pic. A), if this isn’t possible Hinge Cone
(supplied) must be fi tted to the bottom hinge (Pic. E).
2. Align gate with hinge post and fi x hinges to post (Pic B)
3. To Adjust hinge tension, simply use supplied tool (see adjustment
diagrams).
• ONE tension click per hinge at a time
• Check for desired gate tension after each adjustment.
• Aim for equal amounts of tension clicks on each hinge.
• Maximum FOUR tension clicks per hinge.
• Once adjusted fi t the supplied covers to top of hinges (Pic C).
4. Safety cone reduces the risk of children using the hinge as a
foothold to climb over the gate. Must be fi tted to the bottom hinge
if the top of the hinges are less than 900mm apart.

Bracket A must be between 1020mm
and 1050mm from ground level
Top of latch must
be minimum of
1500mm from
ground level.
A
Step 1 & 2
Leave this screw
out until Step 3
Bracket B should
be as high as
possible within
specifi ed range
min 150mm
max 400mm
B
Top of latch must
be minimum of
1500mm from
ground level.
Step 3
HANDLE
Optional handle can be fi xed to gate if required.
Step 5
Gap adjustment
clockwise to increase
Step 6
Step 4
Align
IMPORTANT GAP
3mm-6mm
Step 7
LATCH
1. Position latch bracket A (lower bracket) between 1020mm &
1050mm from ground level. Fix to post with two screws, leaving
the bottom screw out until later (Step. 3).
2. Place latch bracket B (upper bracket) as high as possible within
specifi ed range from bracket A – min. 150mm, max 400mm.
3. Starting at the top slide latch body fully down onto brackets,
then screw to lower bracket.
STRIKER
4. Align Striker bracket with latch using
the alignment notches.
5. Screw bracket to gate using screws
provided.
6. Slide Striker onto bracket, fi x using
adjuster screw
7. Adjust striker clearance 3mm-6mm
turning the adjuster screw clockwise
to increase.
G8SAFE
G8
SAFE
.com.au
CREATING WAVES FOR POOL SAFETY