CAMDEN CM-300 User manual

Page 1 of 1
CM-300 Series
Exit Switch
INSTALLATION INSTRUCTIONS
Door Activation Devices
Camden CM-300 series illuminated Exit
switches are available with stainless-steel
single-gang faceplate (CM-300), or with
Narrow jamb size faceplate (CM-310).
The 1/2” x 3/4” illuminated translucent button
is easy to push, and supplied in momentary or
maintained models. Red buttons are standard
but blue and green are also available.
The supplied LED will work on 12 volts, or
24 volts (using supplied inline resistor).
1. GENERAL DESCRIPTION
2. SPECIFICATIONS
Models CM-300 CM-310
Dimensions 2.75” W x 4.5” H x 1 5/16”
(70mm x 114mm x 33mm)
1.75” W x 4.5” H x 1 5/16”
(44mm x 114mm x 33mm)
Contacts Mom. / Maint.
Switch
Rating 10 amps @ 125 VAC
Electrical
Life 100,000 @ rated capacity
Mounting 2 x #6-32 machine screws
Lens
Colour Red, Green, or Blue
Legend 'EXIT'
LED
Voltage 12 or 24 V DC
2. INSTALLATION
Mounting
1. The colour coded leads are permanently soldered onto the
back of the switch. The Red & Black wires are for the light.
2. For normally open circuits use the Blue & Green wires.
For normally closed circuits use the Yellow & Green wires.
3. Tuck wiring into box and fasten switch plate using screws
provided (CM-300), or tuck wiring into frame and fasten to
frame using screws provided (CM-310).
3. WARRANTY
Camden Door Controls guarantees the CM-300 series to be
free from manufacturing defects for 3 years from date of sale.
If during the rst 3 years a CM-300 series switch fails to perform
correctly, it may be returned to our factory where it will be
repaired or replaced (at our discretion) without charge. There
is no warranty for bulb damage due to over voltage! Except as
stated herein, Camden extends no warranties expressed or
implied regarding function, performance or service.
CM-300RE CM-310E

Call: 1.877.226.3369 / 905.366.3377
Visit: www.camdencontrols.com
Opening New Doors to
Innovation, Quality and Support!
Page 1 of 2
File: CM-300 Series
Installation Instructions.indd R3
Revision: 29/10/2018
Part No.: 40-82B039
CM-300 SERIES EXIT SWITCH
INSTALLATION INSTRUCTIONS
FILENAME: CM-30 Instructions.doc Pg. 2
DRAWING No: DRG-CM300-060503
CM-300 Series Exit Switch Wiring Diagram
SCALE: NONE DRAWN BY: DGW REVISED:
DATE: 03/18/03
Yellow
Blue
Green
Black
Red
Light (-)
Light (+)
Camden Door Controls
NOTE:
LED Replacement
For 12V DC operation, cut off inline-resistor (on Black wire only).
For 24V DC operation, leave inline resistor in place.
Access to LED is obtained by first removing front rectangular lens with
a thin blade screwdriver.
Then, using a pair of needle-nose pliers, carefully pull LED straight out.
Re-installation is reverse of above sequence.
Be sure to line up both pins before pushing LED in.
Rear View of
CM-300 switch
and Faceplate
Normally
Closed
Normally
Open
Common
5502 Timberlea Blvd.
Mississauga, Ontario
L4W 2T7