Campania International FT-221 User manual

FT
-
221 JensenFountain
Revised
April 6, 2017
Pump KitPartsList
PK140 Pump (1)
#7 stopper(1)
Approx.8”length of½”blacknon-kinktubing (1)
CopperSpillers (2)
2.8 oz. tube ofsilicone (1)
Wedges(2)
Hose clamps(3)*
*Hoseclampsmaybe used as flow restrictors
-WINTERCARE-
Fountainbowls/topsandotherfountaincomponents,whichcollect water, shouldnotbeleftoutsideinthewinter since anycomponent,
whichfillswithwater andfreezesmaycrack.Likewise, componentssuchaspedestals,whichremaininabasin,filledwithwater,
whichthenfreezes,mayalsocrackor crumble. Ideally, therefore, afountainshouldalwaysbestoredindoorsor inadryprotected
place suchasacoveredporchawayfromtheelements. However, ifafountainmustbeleftoutside:
(1) Removepump, rubber stoppers, drainpipes, finials,andother smallcomponentsfor storageindoors. Note that stoppersor
drainpipesareremovedtoallowdrainageintheeventwater accumulatesinanybasin.
(2) Raisefountainbasefromgroundwithwood stripssothat basewill notfreeze tothegroundsurface.
(3) Cover or wrapthefountainwithburlapor other absorbentmaterial (oldblanket or towel) andthencover securelywith
plastic,making surethat water will notaccumulate inthebasinor other fountaincomponentandfreeze;
(4) Checkfountainperiodicallytoensurethatplastic issecureandwater isnotaccumulating inanyfountaincomponent.
-GENERALFOUNTAINTIPS-
Install fountainsonalevel surface. Youwill needaproperlygrounded110-volt (AConly) GFCI protectedreceptaclenear the
fountainfor your pump. All pumpsaresubmersible andmustbecompletelyunderwater tofunctionproperly. Testall pumpsand
adjusttofull outputprior toassembly. Itisnotrecommendedthat fountainsbeplaced
directlyongrassor dirt. Positionthechannel opening at thebaseofeachfountaintoward
theelectrical outlettobeusedsince thepumpcord will bethreadedthrough thisopening.
CheckoutYouTubefor a“Howto”video.
For moreCampania product informationvisit www.campaniainternational.com
All of ourcaststone is proudly
FOUNTAININFORMATION:
Thisfountain holdsapproximately3gallonsof water.
Thisfountain usesamediumfountain cover.
(FTNCOV-MED)
Notrecommended for use with refillkits or LED
lightkits.
TOOLSREQUIRED:
Bubble Level
PUMPINFORMATION:
PF140 - 140GPH Pump
6FTcord length

FT
-
221 JensenFountain
Revised
April 6, 2017
Assembleyourfountain onalevelsurface capableofholdingaminimumof90 pounds withan
approximate1square footfootprint.
FT-221C (65lbs)
25.75”Lx18.25”Wx11”H
FT-221B (16lbs)
14.5”Lx9.75”Wx9.5”H
FT-221A(1lb)
4.25”Lx3”Wx4.75”H
1. Position thebasin (FT-221C) where thefountain is to be
installed, ensuringthatitislevel.
2. Assemblethepumpkit
a. Using ahoseclamp, attachthe1/2”non-kink tubing
to thepumpoutlet.
b. Place ahoseclampover theother endofthetubing.
c. Place thestopper aroundthepumpcord
approximately6”fromthepump.
3. Feedthepumpcordthrough theholeandchannelinthe
basin(FT-221C).
4. FIRMLY press thestopper intotheholeevenly.
a. Note:Usingthehandleofascrewdriverorhammer
worksbesttopressthestopperinplace.
5. Position thepedestalwithbowl(FT-221B)overthebasin
(FT-221C).
6. Using thehoseclamp, securetothelooseend ofthenon-
kinktubing to thepipeprotruding fromthebottomofthe
pedestalwithbowl(FT-221B).
7. Center and levelthepedestalwithbowl(FT-221B).
8. Using thesiliconeprovided,place thecopper spillers.
a. Cleanawayanyexcess silicone.
9. Fit thefinial(FT-221A)into thepedestalwithbowl(FT-
221B) byfeeding theprotruding copper pipefromthe
bowlintothecopper pipeholeinthefinial.
10.Letthefountainsit 24hoursbefore fillingwithwater.