Campania International Wiltshire User manual

FT
-
305
Wiltshire
Fountain
Three people are recommended for the installation ofthisfountain!
R
evised
April 23, 2018
-WINTERCARE-
Fountainbowls/topsandotherfountaincomponents,whichcollect water, shouldnotbeleftoutsideinthewinter since anycomponent,
whichfillswithwater andfreezesmaycrack.Likewise, componentssuchaspedestals,whichremaininabasin,filledwithwater,
whichthenfreezes,mayalsocrackor crumble. Ideally, therefore, afountainshouldalwaysbestoredindoorsor inadryprotected
place suchasacoveredporchawayfromtheelements. However, ifafountainmustbeleftoutside:
(1) Removepump, rubber stoppers, drainpipes, finials,andother smallcomponentsfor storageindoors. Note that stoppersor
drainpipesareremovedtoallowdrainageintheeventwater accumulatesinanybasin.
(2) Raisefountainbasefromgroundwithwood stripssothat basewill notfreeze tothegroundsurface.
(3) Cover or wrapthefountainwithburlapor other absorbentmaterial (oldblanket or towel) andthencover securelywith
plastic,making surethat water will notaccumulate inthebasinor other fountaincomponentandfreeze;
(4) Checkfountainperiodicallytoensurethatplastic issecureandwater isnotaccumulating inanyfountaincomponent.
-GENERALFOUNTAINTIPS-
Install fountainsonalevel surface. Youwill needaproperlygrounded110-volt (AConly) GFCI protectedreceptaclenear the
fountainfor your pump. All pumpsaresubmersible andmustbecompletelyunderwater tofunctionproperly. Testall pumpsand
adjusttofull outputprior toassembly. Itisnotrecommendedthat fountainsbeplaceddirectlyongrass or dirt. Positionthechannel
opening at thebaseofeachfountaintoward theelectrical outlet tobeusedsince thepump
cord willbethreadedthroughthisopening.
CheckoutYouTubefor a“Howto”video.
For moreCampania product informationvisit www.campaniainternational.com
All of ourcaststone is proudly
Pump KitPartsList
PK800 pump(1)
Do not use the adapterprovided with the pump
#10 stopper(1)
#7 DrainStopper
Approx.15”length of½”Blacknon-kinktubing (1)**
1”length of5/8”cleartubing (2)**
1”length of3/4"cleartubing (1)**
Wedges (6)
Hose clamps(2) *
*Hoseclampsmaybeused asflowrestrictors
** The tubing hasbeen preassembled
FOUNTAININFORMATION:
Thisfountain holdsapproximately20 gallonsof water.
Thisfountain usesamediumfountain cover.
(FTNCOV-MED)
Compatible withRefill #10 Device and LEDKit
(A different style stopper mayberequestedfor therefillkit.)
TOOLSREQUIRED:
Bubble Level
PUMPINFORMATION:
OEMPP800 - 800GPH Pump
16 FTcord length

FT
-
305
Wiltshire
Fountain
Three people are recommended for the installation ofthisfountain!
R
evised
April 23, 2018
Assembleyourfountainon alevelsurface capableofholdingaminimumof1001 pounds with an approximate
2.75 square footfootprint.
FT-114I(140 lbs)
20”Lx20”W x6”H
FT-114H(150lbs)
15.5”Lx15.5”W x18”H
FT-114G (327lbs)
47”W x6.5”H
FT-305C(52 lbs)
13"Wx14.25"H
FT-305B(65 lbs)
25"Wx8.25"H
FT-305A(37 lbs)
7.75"Wx16.5"H
FT-114F(3lbs)
5.25”Lx2”W x4”H
1. Placethe base (FT-114I)into position wherethe fountain willbe installed, ensuringthat
it islevel.
a. Note:Check thatall components are leveledasthe fountain isassembled.
2. Centerthe large pedestal(FT-114H)overthe base.
3. Assemble the fountain plumbing
a. Attach the 3/4” cleartubingend ofthe tubingassembly to the pump outlet.
i. Note:Donotusethe adapter/flowadjusterthe came with the pump.
b. Placethe stopperaround the pump cord approximately6” fromthe pump.
4. Centerthe large bowl(FT-114G)overthe large pedestal(FT-114H)makingsure the
holesline up.
5. Feed the pump cordallthe waythrough the holesin the bowl(FT-114F)and pedestal
(FT-114H)then outofthe accessdoorinthebase (FT-114I).
6. FIRMLY press the stopperintothe hole evenly.
a. Note:Usingthehandle ofascrewdriverorhammerworksbestto pressthe
stopperin place.
7. Positionthe mediumpedestal(FT-305C)overthe pump inthe large bowl(FT-114G).
8. Feed the tubingconnected to the pump through thetop ofthe mediumpedestal(FT-
305C).
9. Usinga hoseclamp, securethe loose end ofthe tubingassemblyto the pipe protruding
fromthe bottomofthe mediumbowl(FT-305B).
10. Centerthe mediumbowl(FT-305B)overthe mediumpedestal(FT-305C).
11. Fit the finial(FT-305A)into the mediumbowl(FT-305B)byfeedingthe protruding
copperpipe fromthe bowlinto the holeinthe bottomofthe finial.
12. Placethe pump coverdoor(FT-114F)intothemediumpedestal(FT-305C).
13. Fillthe fountain with water.