Canon PIXMA MX392 User manual

Dedicated Fax Line
Setup Guide
MX392
Next

Fax Easy Setup
NextPrevious
Click Next to step through this image-friendly version of Fax Easy Setup.
If you started Fax Easy Setup, on the fax machine’s operation panel, and
prefer to go through this image-friendly version…
Step 1
Press the FAX button at any screen
to go to fax standby mode.
Step 2
Click Next to proceed
through the setup.

Connecting The Phone Lines
NextPrevious

Connecting The Phone Lines
Next
Previous 4
Before
Walljack
After
(PhoneCordincludedwithCanonprinter)
Walljack

If Your Wall Plate Has Two Jacks
Use the jack that supports the fax line.
NextPrevious
5

If Your Wall Plate Has One Jack For Two Lines
If your wall jack provides one jack for two phone lines, it would be best to use a
“2 Line 3 Way Adapter.” This adapter can be purchased at most stores that sell
electronics. This device creates three plugs where there was one. One jack will
be for your voice line. The other jack can be used for your fax transactions. In
most cases, line 1 (L1) is used for phone calls; L2 is used of faxing. The third
jack (L1+L2) allows access to both lines. This is where you would plug in a 2-
line telephone, if available.
The L1 jack is usually your
voice line The L2 jack is usually your fax line
NextPrevious
6

Fax to Phone Line Connection
First, connect one end of the supplied telephone cord to the telephone jack on
the wall.
NextPrevious
7
(PhoneCordincludedwithCanonprinter)
Walljack

Fax to Phone Line Connection
Next, connect the other end of the supplied telephone cord to the lower jack
(labeled “LINE”) on the rear of the MX392.
NextPrevious
8
(PhoneCordincludedwithCanonprinter)
Walljack

Setting Up The Receive Mode
NextPrevious

Step 1
Turn on the MX392 by pressing the
ON button, if it is not powered on
already.
Step 2
Press the FAX button.
NextPrevious
10