Try and flatten the bill of
the cap for CapShields to
fit properly
Step 4:
Select a cap. If the visor is not flat and is significantly curved, it
must be straightened out in order to put the visor clip in place.
Try and select a cap with the flattest bill possible to ease
installation.
Step 5:
Slide the visor clip over the front of the bill of the cap until it is
fully in position. Take care to minimize the gap between the
visor clip and front edge of the bill as an open gap may allow
aerosol or droplets to fall through.
NOTE:
Fogging can occur while wearing
the CapShields in cold weather.
Use an anti fogging spray if this
happens. Do not use if vision is
compromised.
Step 7:
Adjust the headband of the baseball cap for a
comfortable fit.
Step 6:
Carefully remove the outside protective plastic.
ORDERING INFORMATION
P/N CV0010-1 CV-19 Face Shield with Clip $12.95 each
P/N CV0011-1 CV-19 Replacement Face Shield $ 5.95 each
Available in Packs of 1, 5 or 10
(CapShields do not include the baseball cap)
For additional ordering information visit www.capshields.com
www.capshields.com
5/15/20
CAP TM