IMD AGENCY MANUAL www.carima.com
06
PREPARATION AND SETUP
Preparation and
Setup
PRINTING PREPARATION
To start printing, you must first prepare the
materials. Materials include resin vat, resin, and build
plate.
Use protective equipment when using resin.
Pour resin before printing and on inevitable
occasions, press the 'Pause' button and wait
for a complete stop before slowly pouring
the resin into the vat. Adding the resin during
output can cause bubbles and adversely affect
the print.
The FEP film may tear or loosen during
output. In this case, replace it with a new
one to prevent resin leakage. It may get
scratched due to user carelessness or by
hardened outputs. Be aware, for it may
occur in short-term use.
Clean the build plate by scraping it off
with a scraper or by wiping with alcohol.
Thoroughly wipe the resin off before using
a different resin.
The lifespan of the optical engine lamp is
20,000 hours. When it exceeds 20,000
hours, the brightness of the lamp may
decrease. Once it exceeds its usage time,
improve the quality of the output by
replacing it with a new lamp.
Align the detached vat and fasten it to
the vat retention knob.
Fasten the plate to the build plate fixing base
and to the module with the fixing fin.
Pour the resin into the resin vat.
Scratching the FEP film with sharp scrapers
or cutters will tear and contaminate the
engine room due to leakage of resin.
* Build plate, vat, FEP film, etc. are accessories.
To purchase additional accessories, contact Carima.
Information on the use of resin
Information on the use of resin vat
Information on maintaining the
build plate
Information on optical engine
