CashCode AMZ-154 User manual

CashCode - Installation Instructions for the New $ 5 and $ 10 upgrade kit - Version 05-00
Stacker models AMZ-154, AMZ-PLUS and AMZ-1100
Page 1 of 3
INSTALLATION INSTRUCTIONS FOR
THE NEW $ 5 AND 10 UPGRADE KIT
Stacker models AMZ-154, AMZ-PLUS and AMZ-1100
PARTS ENCLOSED:
1 x CPU chip with embedded program for 154 and PLUS models or Prom for 1100 models
1 x Label "New $ 5 & $ 10 Ready"
TOOLS REQUIRED:
Wrist ground strap PLCC extraction tool
CashCode Co. Inc.
553 Basaltic Road
Concord, Ontario
Canada L4K 4W8
Tel. [phone]
Fax [phone]
Web Site: www.cashcode.com
_____________________________________________________________________

CashCode - Installation Instructions for the New $ 5 and $ 10 upgrade kit
Stacker models AMZ-154, AMZ-PLUS and AMZ-1100
Page 2 of 3
INSTRUCTIONS:
STEP 1: Remove banknote cassette from validator and remove metal cover plate (lift cover
plate as marked by the label on the plate).
STEP 2: Attach the ground strap to your wrist and the other end with the clip to a metal water
pipe or electric ground.
STEP 3: Locate the CPU chip (AMZ-154 and AMZ-PLUS models) or the PROM chip
(AMZ-1100 models).
IMPORTANT: Note the location of the chamfered edge before you remove the
chip.
AMZ-154 and AMZ-PLUS models AMZ-1100 models
STACKER ASS
'
Y
REMOVE THE COVER
BEFORE INSTALLING THE CHIP

CashCode - Installation Instructions for the New $ 5 and $ 10 upgrade kit
Stacker models AMZ-154, AMZ-PLUS and AMZ-1100
Page 3 of 3
STEP 4: Locate the corner slots in the socket and insert the hooks of the extraction tool. While
gently squeezing the tool, the chip can be lifted out of the socket. Pay attention to the
fact that one corner of the chip has a chamfered edge. The socket also has a corner to
fit this edge.
INSERT
EXTRACTOR
TOOL HOOK INSERT
HERE EXTRACTOR
TOOL HOOK
HERE
CHAMFERED
HOOKS EDGE
STEP 5: Locate the chamfered edge on the new chip, place the new chip in the socket and
press down. NOTE: The chip should go down into the socket with little effort. DO NOT
FORCE IT. DO NOT ALIGN THE CHIP ACCORDING TO THE POSITION OF THE
LABEL. MATCH THE CHAMFERED EDGE.
CPU Chip Prom Chip
CHAMFERED EDGE
NOTE: 24 Volt models use US3B-S30 or US4B-S30 CPU chip.
STEP 6: DIP switch settings do not change. Re-install the cover plate and your cassette, and
apply the update sticker to the outside of your validator for reference.
STEP 7: Power up the validator and begin accepting the new $ 5 and $ 10 bills.
US6R
_S30
US2A_S30
or
US4A S30