Cavalry CAUQ25100 User manual

CAUQ Series Fingerprint Security Guide
The Cavalry Mobile External Storage unit is a device to secure your data via fingerprint, and to
prevent unauthorized access. Once set up, the hard disk will appear after the fingerprint or
password has been verified successfully.
How to use
Step 1: Insert HDD and plug the device into USB port.
Step 2: Double-click on the setup.exe icon to adjust the capacity of PUBLIC and SECURITY.
Then click on START for partition procedure. This may take a few minutes.
Step 3: The fingerprint software will be loaded into HDD automatically after partitioning and
formatting PUBLIC (E :) and SECURITY (F :)
Step 4: Execute the fingerprint software in AP Disk by double clicking to enable fingerprint
features.
CA1163
070108

Registration of the fingerprint / password
Step 1: The window of fingerprint registration will show up.
Step 2: Put the mouse over the finger you want to register.
CA1163
070108

Step 3: Click the desired finger and click “Next” for registration. You can register up to 10
fingerprints.
Step 4: Exit “Fingerprint Registration”.
Step 5: Put the same finger on the fingerprint sensor and slide as many times as necessary (3
or more).
Note: Your finger must be placed on sensor, then swipe the sensor from the bottom of the tip
of the finger to the top of the tip of the finger.
Step 6: Return to “Fingerprint Registration”. You can choose “End” to complete or “Back” to go
back to step 3 to register another finger.
CA1163
070108

Step 7: After completing “Fingerprint Registration”, the “Fingerprint Software Password
Setting” window will appear.
Step 8: Follow the instructions and type in the password. Then choose “Confirm” to finish.
CA1163
070108