Cavecool CC06BM User manual

1
USER GUIDE
Cavecool Joy Opal – CC06BM
WWW.CAVECOOL.COM

2
General
Please read the information contained herein so that you can become familiar
with your device quickly and take advantage of the full scope of its functions.
This user guide will provide important information for the initial commissioning,
safety, intended use and care of the device.
Warning
If a dangerous situation is not avoided, this can lead to death or serious
injuries. Follow the instructions to avoid the danger of death or serious
personal injuries.
Safety
To reduce the risk of fire, electrical shock, or injury when using your appliance,
follow these basic precautions.
• PLEASE READ all instructions before installing, operating, or servicing
the appliance.
• DANGER AND WARNING: Failure to follow this safety statement may
result in severe personal injury or death, property or equipment
damage.
• Never attempt to repair or perform maintenance on the unit until the
electricity has been disconnected.
• Never remove the round grounding prong from the plug and never use
a two-prong grounding adaptor.
• Altering, cutting of power cord, removal of power cord, removal of
power plug, or direct wiring can cause serious injury, fire or loss of
property and life, and will void the warranty.
• Never use an extension cord to connect power to the unit.

3
Disposal of packaging
The packaging protects the device against damages during transportation.
When disposing the recyclable packaging, please follow disposal regulations.
Important precautions
l Do not lift unit by door handle.
l Keep the door closed before installing.
l Ambient temperature below 10°C or above 32°C will hinder the
performance of the appliance.
l This unit is not designed for use in a garage, shed or any other outside
installation.
l Be sure the back plate and two flanks are free from obstruction.
Obstructing free airflow can cause the unit to malfunction and will void the
warranty.
l Allow unit temperature to stabilize for 24 hours before use.
l Do not block any internal fans.
l Use only genuine supplier's replacement parts. Imitation parts can
damage the unit, affect its operation or performance and may void the
warranty.

4
Installation
Before using your wine cooler:
• Remove the exterior and interior packing.
• Before connecting the appliance to the power outlet, let it stand upright
for approximately 2 hours. This will reduce the possibility of malfunction
in the cooling system from handing during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a tabletop strong enough to support the
appliance when fully loaded.
• To level your appliance, adjust the front legs at the bottom of the
appliance.
Bottle shelves
Remove all bottles from the shelves. Lift the shelf upwards and gently pull it
out. The wine shelves can be removed to accommodate larger bottles.

5
Design and function
Device overview
1. Light
2. Fan mask
3. Shelf
4. Condensation water box
5. Foot
6. Bottom condensation water
box
7. Magnetic seal
8. Door frame
9. Hinge and foot
10. Door handle
11. Temperature indicator
12. Light switch

6
Operating your wine cooler
It is recommended that you install the wine cooler in a place where the ambient
temperature is between 10°C and 32°C. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
Button functions
l The temperature can be set in the range 10-18°C.
l The temperature can be adjusted by 1°C.
l After set the desired temperature, the set temperature will flash for 3 seconds on the
display and then revert back to displaying the internal cabinet temperature.
Set the temperature to display
Celsius or Fahrenheit.
Turn up the desired
temperature.
Turn down the
desired temperature.
Turn the light on/off.

7
Cleaning and maintenance
Attention
l Prior to commissioning, clean the appliance thoroughly.
l Before cleaning switch off the wine cabinet and unplug from the wall power outlet.
Remove all content.
l Do not use aggressive or abrasive cleaning agents or solvents.
Cleaning
l Wash the inside with a damp cloth soaked in lukewarm water and a bit of mild
detergent.
l After cleaning the interior, leave the door open until the interior of the device is
completely dry.
l If condensation is formed inside, please wipe the inside with a soft cloth.
l Be sure to keep the door gasket clean to keep the unit running efficiently.
l Use a soft cloth for drying.
Moving the appliance
Turn off the appliance first and unplug the unit from the wall outlet. Remove all content.
Securely tape down all loose items inside your appliance. Tape door shut. Make sure that
the device stays in the upright position during transportation.

8
Troubleshooting
Fault
Possible cause
Wine refrigerator did not turn on.
Not plugged into the correct voltage. Also, the
circuit breaker may have tripped or a blown
fuse.
Wine refrigerator is not cold enough.
Check the temperature control setting.
External environment may require a higher
setting. The door is open too often.
The door is not closed completely. The door
seal does not seal properly.
The wine refrigerator does not have the
correct clearance. The fan cover is dirty.
Please clean the fan cover.
The light does not work.
Please call the warranty service number.
Vibrations
Check to ensure that the wine refrigerator is
level.
The wine refrigerator seems to make too
much noise.
The wine refrigerator is not level. Also, please
check the fan.
The door will not close properly.
The wine refrigerator is not level. The door is
not properly installed. The sealing is weak.
The shelves are out of position.
LED display error.
Please call the warranty service number.
Condensed water on the surface of cabinet.
There may be some water condensation on
the surface of wine cabinet (especially the
glass door) if the item is in a damp room.
Please wipe it away with dry cloth.
Condensation formed inside the cabinet.
If the environment has a high level of
humidity or the door of wine cabinet has been
left open for a long period or opened
frequently, wipe off the door and walls and
leave the door closed as long as possible.

9
Disposal of the device
Old electric and electronic devices may contain valuable materials and/or damaging
substances. Therefore, do not put your old device into the non-recyclable waste under any
circumstances.
Technical data
Model No.
CC06BM
Capacity
18 L
Voltage
AC220-240V
Rated current
1A
Frequency
50Hz
Input power
70W (25°C)
Power consumption (kWh/24h)
0.3 (15°C)
Max. temperature difference
>18°C
Temperature control range
8-18°C
Net weight
9 Kg
Product size (W x H x D)
26,5 x 40,5 x 50 cm.