Cavius 2107-001 User manual

PLEASE READ THIS USER GUIDE CAREFULLY
PHOTOELECTRIC SMOKE ALARM
THE WORLD’S SMALLEST

PLEASE READ THE USER GUIDE CAREFULLY BEFORE
INSTALLATION AND RETAIN FOR FUTURE USE.
CAVIUS Photoelectric Smoke Alarm
Part Code: 2107-002/10022/10026
Model: 2107-001
Recess Kit Part Code: 11014
For large text option and maintenance guide visit
cavius.co.nz/resources or cavius.com.au/resources
1
TECHNICAL INFORMATION
The maximum number of CAVIUS Wireless Family alarms that can be
interconnected within a house group are 32.
Please note: These must be alarms from the CAVIUS Wireless Family range.
The distance between interconnected alarms depends on the house layout
and they should always be tested after installation. It is not advised to be
more than 10m distance between two alarms.
Diameter: 78mm
Height: 43mm

2 3
The alarm is powered by two 3v CR123A lithium batteries.
Interconnected by RF: 926.365 MHz
Complies to standards: AS3786:2014/RCM
Alarm condition aural signal pattern according to ISO 8201.
1. The best areas to install an alarm:
 • Installalarmsoneachoorofthehouse,inhallwaysandstairways.
 • Alarmsineachroomsuchasbedroomsandlivingrooms.

2. Areas where NOT to install smoke alarms:
 • Industyrooms
 • Atthetopofahighpointedceiling,incornersofaroom,andwithin
50cm of where a ceiling and wall join.
 • Inroomswherethetemperaturegoesoutside+4cto38corabove90%
relative humidity not condensing.
 • Inkitchens,garages,laundries,ortooclosetoreplaces;areaswhere
  eitherdampness,gasesorheatcouldoccur.Placethealarmwhereitis
reachable in order to test the battery and for maintenance.
45
3. Placement:
The smoke alarm is designed to be installed on a ceiling (preferred) or wall.
Ceiling installation:
The smoke alarm should be a minimum of 50cm from the wall.
Minimum 50cm
from peak.
Ceiling
Wall

For catheral or peak ceiling or wall installation:
Forcathedralorpeakceiling;aminimumof50cmfromthepeak
6 7
Minimum 50cm
from peak.
Ceiling Ceiling
Forwallinstallation;aminimumof30cmandmaximumof50cmfromthe
ceiling.
Minimum 30cm and
maximum 50cm from
ceiling
Wall
4. How to set up and connect alarms:
All alarms that need to be connected in the house should be put into ‘Link Mode’
by sliding the switch on the back of the alarm to the ‘Link Mode’ position.
LINK MODE
NORMAL MODE

89
Press the button on the top of one alarm only. This alarm will become the
‘Master’andwillstartsendingoutaspecichousecodetotheotheralarms
(takenoteofwhichalarmisthe‘Master’,youmayneedthisforaddingextra
devicesinfuture).TheredLEDwillash.
Astheotheralarmsreceivethespecichousecode,theywillalsoashthe
LEDlight.WhenallalarmsashtheredLED,theyareconnectedandcanbe
switched out of ‘Link Mode’ and installed.
Remove the Safety lock from the
mounting base.
Place the Safety lock into the slot once
the alarm has been clicked into the
base. To remove the Safety lock in
future,youwillrequireascrewdriverand
we advise to not be too forceful when
removing.

10 11
MARK UP
SCREW HOLES
WITH A PEN
5. Installation of smoke alarm:
Info: The label on the product must not be removed
due to
important information.
Option 1 – Standard base
1. Use the mounting base ring to mark the screw
holes on the ceiling.
USE THE
ENCLOSED
SCREWS AND
PLUGS FOR
INSTALLATION
CLICK THE SMOKE
ALARM FIRMLY INTO
THE BASE TO ACTIVATE

12 13
Option 2 – Recess Kit
1. Place the Cover Ring on the area where you wish to install the smoke
alarm,tracearoundtheinsideofthering.
HOLE SAW
DRILL REQUIRED.
81mm - 85mm
INSERT RECESS KIT
MOUNTING BASE INTO
THE HOLE AND SECURE
WITH SCREWS
PLACE COVER RING
AROUND THE RECESS
KIT MOUNTING BASE
CLICK THE SMOKE
ALARM FIRMLY INTO
THE BASE TO ACTIVATE
2. Using your hole saw
(81mm-85mm),cuta
hole into the surface.
CAUTION: Ensure
there is no wiring or any
electricalequipment
behind the surface you
are drilling your hole into.
NOTE: The Safety lock
cannot be used when
installing the alarm with
the Recess Kit base
option.

1514
6. Test function:
Afterinstallation,andatleastonceperquarter,testallofyouralarmstoensure
they are operating correctly and are within range of each other.
ItisrecommendedtocheckvisuallyeveryweekiftheLEDashescorrectly
(every 48sec.)
Press the test button on any alarm for at least 6.5 seconds (count 2 sets of
3soundsweeps).Thiswillsendoutatestsignalfromthealarm;allother
connected alarms should receive the signal within a short time. The alarms will
emitashortbeepandtheLEDwillashevery8secondsfor2minutes.
When the test signal is sent out, the alarms will respond in two ways:
1. A single beep every 8 seconds indicates that the alarms are connected
and functioning.
2. Three short beeps every 8 seconds indicates a smoke sensor fault.
The alarm should be cleaned by running the vacuum (on a low setting)
around the smoke alarm chamber and tested again.
Oncethealarmshaveindicatedtheyareinterconnected;thebeepscanbe
stopped on each alarm with a short press of the test button.
TIP:Itissafetocoverthesoundoutputholewithyourngerduringthe
testing to minimise the sound level emitted.
Ifanyproblemsoccurduringtesting,visitwww.cavius.co.nzor
www.cavius.com.au for further trouble shooting.

16 17
7. Normal mode:
InnormalmodetheLEDwillashevery48secondstoshowthealarmis
functioning.
8. Alarm mode:
Whenaconcentrationofsmokeisdetected,thesmokealarmwillgointo
‘AlarmMode’.ItwillsoundthealarmsignalandtheLEDwillash.Pleasenote
thatonlythesourcealarm’sLEDwillash,soitcanbeidentied.
The smoke alarm will also transmit the alarm signal to the other connected
alarms,whichwillalsosoundthealarmsignalafterashortdelay.
9. Hush function:
Ifthesmokealarmsaretosetintoafalsealarmbycooking,replace,etc.
all of them can be paused for 10 minutes by pressing the test button on the
originatingsmokealarmonly(indicatedbytheashingLED).
Youcanhusheachalarmindividually,howeverthesourcealarmwillcontinue
to sound until hushed.
The reason for this is that it is necessary to locate the source of the alarm
before using the hush function. This is to make sure that it is not a life
threatening situation.

10. Add extra device:
All CAVIUS interconnected alarms within the
rangecanbeaddedtothesystemastheyrunonthesamefrequencyanduse
the same data protocol. This means that the wireless system can consist of a
combination of smoke alarms and heat alarms.
Justplacethe‘Master’andnewdeviceinto‘LinkMode’,repeatSection4.
Always test connection to all devices by repeating the test function (Section 7)
after adding alarms.
1918
Low battery indicator: A short acoustic “beep” will sound and the LED will
ashevery48secondswhenthebatteryisneartheendofitslife.Inthisstage
it will continue for a minimum of 30 days.
Youmustreplacethesmokealarmafter10yearsofuse,orifthesmokealarm
hassueredanydamage.Thesmokealarmisnotactiveunlessitisclicked
into the mounting base.
Alwaystestthesmokealarmafterclickingintothemountingbase,allow5
seconds before testing.

20 21
FUNCTIONAL INFORMATION
Type of alarm: CAVIUS smoke alarm is a photoelectric smoke alarm.
Alarm signal: Fire alarm activation is indicated by a series of repeated tones.
The minimum sound level is 85 dB at 3 metres.
Battery: Powered by two non-replaceable
3vCR123A,1600mAhlithiumbatteries.
Developed & Manufactured by:
Aps
Julsøvej 16 - DK8600 Silkeborg
cavius.com - [email protected]
Manufactured in P.R.C.
Distributor information:
for New Zealand - CAVIUS Nano Ltd.
58aPoplarLane,Papamoa3187,NZ. www.cavius.co.nz
for Australia - CAVIUS Australia
14/30OctalStreet,Yatala,QLD4207,Australia.www.cavius.com.au

22 23
Warranty:
CAVIUS provides a 10-year warranty against defect in faulty material and workmanship from
thedateofpurchase,onalldevices.
The warranty applies to reasonable and normal conditions of use only. It does not include
damageasaresultofmisuse,incorrectinstallation,accidentaldamage,neglect,unauthorised
deconstruction or dismantling and any airborne or other contamination however this may
have occurred.
If this product has an acknowledged defect it must be returned to the national CAVIUS
Distributor at the purchasers cost with the proof of purchase.
Iftheproducthasbecomedefectivewithinthe10-yearwarranty,CAVIUSAPS,Denmark
willrepairorreplacetheunitwithoutchargeandsendbacktothepurchaser,viathenational
Distributor at the Distributors cost.
Theguaranteeexcludeslabourcosts,freightcosts,servicecostsandanyincidentaland
consequentialdamages.Donotattempttorepairorservicethisproductasthiswillinvalidate
the warranty.
Under some unusual circumstances the presence of high levels of radio spectrum pollution
may result in the batteries within the CAVIUS device not lasting as indicated in the product
sheet. Radio spectrum pollution comprises transmissions inside the band allocated for alarm
devices such as the CAVIUS devices. Such transmissions may activate the receiver inside the
devices for a longer time than is normal in standby.
ThisisnotaspecicproblemforCAVIUSdevicesbutforallsimilarradiolinkedtechnology
powered by batteries. The limited warranty will not cover the battery life period indicated in the
product sheet in these situations.
This warranty is in lieu of any other warranty either expressed or implied.
You can register your CAVIUS devices on our website.
127483 rev3

PLEASE READ THIS USER GUIDE CAREFULLY
PHOTOELECTRIC SMOKE ALARM
THE WORLD’S SMALLEST