CB2 Smart User manual

Customer Service 800.606.6252 | www.cb2.com
1
Made in Taiwan - r01 Page 1 of 2
smart MARBLE CONSOLE TABLE
hardware
components
tools required
Thank you for purchasing the Smart Marble Console
Table. This page lists all the contents included in the
box. Please take the time to identify the hardware as
well as the individual components to this product. As
you unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect them
from damage.
Note: 2 people are required to safely assemble this product.
Missing hardware?
Please call 800.606.6387 for replacements.
16 - bolts 8 - spring
washers
4 - feet
6 - rubber
bumpers
allen wrench (included)
2 - frames
(1 front, 1 back)
1 - marble panel
4 - crossbars
A. With the assistance of another adult, carefully
place 2 frames with the holes facing upwards
onto a clean, padded surface. Attach 1
connecting bracket with 1 bolt and 1 spring
washer per corner as shown. Secure bolts with
an allen wrench. Make sure holes on each
connecting bracket are facing downwards.
B. Insert 2 feet into each frame as shown. Press
feet firmly to secure.
Make sure holes on each
connecting bracket are facing
downwards when assembling
8 - connecting
brackets
A
B

Customer Service 800.606.6252 | www.cb2.com
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the unit is finished with a protect clear lacquer.
cleaning & care
Immediately use a slightly damp cloth to wipe the tabletop since
marble is extremely porous. Spot clean with mild detergent and
water. Be aware that the color and natural veining will vary with
each piece. Coasters must be used to protect from heat and water.
Loosely attach remaining frame onto assembled
unit with 1 bolt per crossbar as shown. Do not
fully tighten the bolts until further instructions.
smart MARBLE CONSOLE TABLE
Made in Taiwan - r01 Page 2 of 2
2 3
4
With the assistance of another adult, carefully
position assembled unit upside down. Fully tighten
all bolts with an allen wrench. Slightly adjust
assembly if needed.
5
Loosely attach 4 crossbars onto frame with 1 bolt
per crossbar as shown. Make sure holes on
crossbar face downwards. Do not fully tighten the
bolts until further instructions.
A
B
A. With the assistance of another adult, carefully
position assembled unit upright. Adhere 6 rubber
bumpers onto top of assembled unit as shown.
Press firmly to secure.
B. Carefully place marble panel onto assembled
unit as shown. Assembly is now complete.
NOTE: Do not
fully tighten the
bolts.