Celsius Celepaneld User manual

OPERATING INSTRUCTIONS
PANEL HEATER
For Model: CELEPANELD

1. Use only the voltage specified on the rating
label of the appliance.
2. Keep all objects at least 1 metre from the
front and sides of the appliance. Do not
place appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage
to the appliance.Do not sit on the appliance.
5. Do not operate this appliance with a
damaged cord, plug or after the appliance
malfunctions or has been dropped or
damaged in any manner. Return to a qualified
electrical person for examination, electrical
service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended
by the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is
deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly
by unplugging the appliance and vacuum
cleaning the air vents and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always
remove plug from the mains supply before
cleaning.
10. Do not connect the appliance to mains supply
until completely assembled and adjusted.
11. Switch off when moving.
12. Do not operate with cord set coiled up as a
heat build up is likely, which could be
sufficient to become a hazard.
13. Do not use an extension cord, power board or
external timer with this appliance.
14. Do not remove plug from power socket until
the appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord; always grip plug.
16. Always unplug appliance when not in use.
17. Do not locate the heater directly below any
power socket during operation.
18. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage
area and is unrolled before use.
19. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge, unless
they are supervised or have been given
instruction concerning the use of the
appliance by a person responsible for their
safety.
20. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not
be immersed in any liquids.
21. When the appliance has been unpacked,
check it for transport damage and ensure all
parts have been delivered. If parts are
missing or the appliance has been damaged,
contact the Celsius Customer Services Team.
22. If your appliance does not work, or is not
working properly, contact the place of
purchase or the Celsius Customer Services
Team. Repair work on the appliance by
unqualified persons can cause serious risk to
the user.
23. There are no user serviceable parts installed
in the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
25. This unit is not supposed to be used in or
around locations where foodstuffs, works of
art or delicate articles of science, etc are
stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
WARNINGS AND SAFEGUARDS
Celsius –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
Celsius –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
SUPPORT AND TECHNICAL ADVICE

WALL MOUNTING POSITION INSTRUCTIONS
NOTE: Your Celsius panel heater should be installed with at least 300mm clearance from the
floor and any other surrounding parts including other appliances, side walls, ceilings, shelves
and soft furnishings.
300mm
300mm
300mm
300mm
CONTENTS
1 x Celsius panel heater
1 x Wall mounting accessories pack
2 x Drill bits (1 x 7mm for plasterboard or wooden walls, 1 x 8mm for drilling masonry)
4 x Rail fittings
4 x Screw bolts
4 x Bolt caps
NOTE: Please ensure you use the correct drill bit for the wall surface material you are mounting on to.
Please contact your local hardware retailer or builder for advice.

WALL MOUNTING INSTRUCTIONS
Always choose a safe location for the heater, keeping in mind the safety precautions outlined.
Ensure all packaging and the wall mounting accessories pack has been removed from the unit
before use.
1. Mark the positions of the four holes to be drilled on the wall. Ensure there is a 300mm
clearance on all sides of the heater.
2. Drill holes with an appropriate drill bit for the wall type you are mounting the heater on to.
3. Insert the plastic rail fittings into the holes.
4. Install the panel heater onto the four rail fittings matching the four holes on the heater.
5. Screw the four screw bolts into the plastic rail fittings.
6. Put the caps onto the end of the screw bolts. It is recommended to use some normal glue
to stick the caps onto the bolts.
To remove the unit from the wall, simply remove the bolt caps, unscrew the bolts with a screw driver
and take the heater down

OVERVIEW OF YOUR CELSIUS PANEL HEATER
Your Celsius Panel Heater will provide background warmth.
Your Panel Heater is designed to take the chill off the room.
The surface of this Panel Heater can be painted with good quality paint (acrylic or enamel).
Decorating tip: All wall mounted heaters may cause paint to discolour or wall paper to lift.
CARE AND CLEANING
Do not attempt to dismantle the Panel Heater. There are no user serviceable parts. For service or
repair, contact an authorised electrical service technician.
Unplug the heater from the mains supply before cleaning. Ensure that the heater has been allowed to
cool down completely before cleaning.
To remove the unit from the wall, simply remove the bolt caps, unscrew the bolts with a screw driver
and then take the heater down. Use a vacuum cleaner to remove dust and fluff from behind the
heater.
The outside can be cleaned by wiping it over with a soft dry cloth.
NOTE: Do not use abrasive cleaning agents or polish, this can damage the surface and finish.
For short term non-use, simply turn off the unit with the power switch on the side of the heater and
disconnect the mains power supply at the wall.
SAFETY FEATURE
In case of overheating, this heater is fitted with a thermal fuse which is located inside the construction
of the heater. If this thermal fuse activates it will turn the heater off however the light in the power
switch will remain on to let you know there is still power going into the heater.
In the event that this happens, turn the heater off at the switch and the wall socket and unplug it. Then
contact our Customer Service Team.
WARNING: Do not use this heater with a programmer, remote-control system , separate timer or any
other device that switches the heater on automatically, since a fire risk exists if the heater is covered
or positioned incorrectly.
WARNING: Keep all objects at least 1 metre from the front and sides of the appliance.
CAUTION: The heater generates heat during use. Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to persons.
IMPORTANT! NEVER COVER THIS HEATER
OPERATING INSTRUCTIONS
Before plugging in and using your new Celsius panel heater, check all surfaces to ensure the heater
is not damaged in any way.
Check that the On/Off switch is set to the Off position before plugging the heater into the mains
supply.
Use the On/Off switch along the side of the heater to turn your heater on.
WARNING! Take care in positioning your heater, using the timer will mean the heater will come on
automatically. Fire may result if placed next to combustible material.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. Refer to back of booklet.
TECHNICAL SPECIFICATION
Model No: CELEPANELD
Supply: 220-240VAC 50Hz
Wattage: 400-425W