Cenocco home CC-9092 User manual

CLEANING & STORING INSTRUCTION
When cleaning and drying the mop, use the appropriate slot to achieve desired effect.
Step 1: CLEANING
First, fill the water tank to its
maximum level. Then, drag the PVA
mop refill.
Step 2: DRYING
Drag the PVA mop refill into the sink
and press it down until you hear a
“click”sound.
Step 3: STORING THE MOP & BUCKET
After use, place the mop/ hang the
mop into a cool and well-ventilated
room.
PVA MOP
DRY/ WET USE
PVA MOP HEAD
MULTI-FUNCTIONAL
MANY USES
Before using, please make sure that all the parts are closely and
securely connected.
Steps in connecting the parts and components of the unit:

WARNING
Please read the contents in this item carefully before using the product, so as not to cause
inconvenience to your life by wrong operation of the product
Make sure the product is placed in a horizontal place before use.
Before use, please keep the center of gravity of the product not moving, and make sure that the
product is placed on the anti-skid floor, so as not to roll over during use. Before use, please make
sure that the parts of the mop rod are closely connected, otherwise the product may be out of hand
control during use.
When using, do not put your finger into the top hook when the product is in operation, so as not to
harm your finger.
When using, please do not let children play near the product during operation, especially do not
hold out your hand, to avoid the danger of hand clamping.
When using, do not insert other items into the working cleaning bucket while the product is in
operation to avoid damage.
This product is a plastic product, please do not put the product in an open fire, hot, cool
environment, otherwise it will cause deformation, damage, burning, cracking and other products to
reduce the performance of the product, or even destroy the product.
Do not allow children to use this product alone. Protect the children around you from danger when
using this product.
Do not soak or clean with strong acid detergent, do not soak bleach for a long time.
Keep the mop in a cool and ventilated place
When replacing the mop head, please make sure it is moist and soft. If it appears to be hardened,
just soak in water. Do not pull hard to cause damage.
Do not exceed the maximum water level when filling the bucket, and keep the rod 90 degrees upright when cleaning
MOP HANDLE AND SQUEEZE WATER ROD INSTALLATION
Align the upper rod with the middle
rod and tighten it clockwise (the
same applies to the lower rod).
Insert the middle buckle of the rubber
cotton towing head into the hole
position.
Press down both ends of the rubber
cotton drag head buckle, hear
"click" sound, that is it, the
installation is completed.