Chef-Master HEC822 User manual

Chefmaster Rise and Fall Salamander
Instruction Manual
Models
HEC822

2
Thank you for purchasing your Chefmaster Rise and Fall Salamander. To
make full use of the product please read this manual carefully before
using the product and keep it safe for future reference.
Safety Tips
•If you find any damage when the product is unpacked, contact your
Chefmaster supplier within 24 hours of receipt of goods
•Always position on a flat stable surface
•Do not place any items on top of the salamander grill
•Repairs should always be carried out by a qualified technician
•DO NOT submerge this product in water.
•Do not use direct jets/ high pressure water/ jet-clean-spray to clean this
product.
•Do not use this product outdoors or place it in environments where
there is open fire such as gas stove or kerosene stove in use
•Always switch off or unplug the unit before cleaning
•Always pull up and down the grill hood with plastic handle only
•Move by holding the product by the base
•Always plug into a grounded outlet. Do not use an adapter or an
extension cord.
•If the power cord becomes damaged it must be replaced by a qualified
technician
•This product is not designed to be used by persons with reduced
physical or mental capabilities, lack of experience or knowledge, unless
they are given suitable supervision, this includes children.
Pack Contents
•1 x Chefmaster Rise & Fall Salamander
•1 x Grill Rack
•1 x Drip Tray
•1 x Manual
Before Use
•Remove all packaging including all protective plastic from your
Chefmaster Salamander
•Position on a flat surface or properly mounted wall shelf
•Ensure the drip tray is correctly positioned
•Plug your Chefmaster Salamander into the mains
•The machine will now be ready to turn on

3
Operation
•Ensure the Salamander is plugged in and the green light is on
•Select the temperature you require with the dial, the yellow heating
indicator light will be on. The maximum temperature of this product is
300 °C
•Raise the grill hood to the top and place food on the grill rack. Lower the
hood to a desired position and cook.
•Once the salamander has reached the desired temperature, the yellow
heating light will switch off. The green power light remains on as long as
the power is connected and the unit is on.
•Raise the grill hood to the top with the handle and the food is now ready
to take out
•When temperature lowers, the yellow light will be on and the
salamander will heat up again automatically until the dial is turned to “0”
position
Note: If the dial is turned to maximum position, the
salamander will heat continuously with maximum temperature
Note: This unit has a re-set button on the base. The Salamander will
automatically turn off if the temperature is too high. Once the appliance cools
down, press the re-set button to resume the function.
Cleaning & Maintenance
•Before cleaning disconnect the salamander from the power supply.
•Allow the salamander to cool down before cleaning.
•The rack and drip tray are removable for cleaning.
•All other parts of the salamander can be cleaned with a damp cloth
•DO NOT submerge the salamander in water or use water sprays to
clean it.
•Always clean your Chefmaster Salamander daily to avoid grease build
up
•Use only non-abrasive cleaners and pads. Abrasive cleaners and
scouring pads could scratch the finish of the salamander.

4
Troubleshooting
Condition
Possible Cause
Solution
The unit is plugged in but
power indicator is not on &
the unit is not working
1. The unit is not
switched on
2. The plug or lead are
damaged
3. The fuse has blown
4. Overheat protection is
triggered
1. Check the unit is correctly
plugged in and switched on
2. Contact your Chefmaster
distributor
3. Replace the fuse
4. Cool the unit for about 30
minutes, then press “reset”
button on the base
The grill hood is not
heating when the power
and heating indicator are
both on
1. Temperature
controller may be broken
2. At least one of heating
wires may have burnt
out
1. Contact your Chefmaster
distributor
2. Contact your Chefmaster
distributor
The power is
on/temperature controller
is switched and heating
indicator is on, the
temperature cannot be
controlled
The thermostat may
need to be replaced
Contact your Chefmaster
distributor
Indicator is not on when
the power is on and the
unit is heating
Power indicator light
may need to be replaced
Contact your Chefmaster
distributor
Transportation and Storage
Please handle your salamander with care to prevent any damage to the unit
and internal parts.
The product should be stored in a well ventilated area. Do not store any
flammable objects near the equipment.
Technical Information
HEC822 –Chefmaster Rise & Fall Salamander
Voltage ~230v 50/60Hz
Power 2.8Kw
Weight 38.5kg
Dimensions 450 x 450 x 500
•Chefmaster Salamander is supplied with a 3 pin plug and lead with a 13

5
amp fuse
•Appliance must be earthed
•If in doubt contact a qualified electrician or your Chefmaster distributor
Disposal
Under WEEE regulations this product must not be disposed of as household
waste. To prevent damage to the environment and humans this product must
be disposed of in an approved and environmentally friendly recycling process.
For more information on how to dispose of this correctly please contact your
Chefmaster distributor or local authority responsible for waste disposal.
Compliance
All Chefmaster parts and products have under gone a stringent testing process
to ensure that comply with all European standards and specifications.
All Chefmaster products carry the CE approval symbol.