CP716
Air Hammer
Technical Data
0.401 in. (10mm) shank
Air Pressure 90 psi (6.3 bar)
Bore and Stroke: 3/4 x 2.25 in (19 x 58mm)
BPM: 3500
Noise & Vibration Declaration*
Sound pressure level 103 dB(A), uncertainty 3 dB(A), in
accordance with EN ISO 15744. For sound power, add 11
dB(A).
Vibration value;
a= 5,5 m/s2, uncertainty k= 1,9 m/s2, re. ISO 28927-9
Declaration of noise and vibration emission
All values are current as of the date of this publication. For the
latest information please visit cp.com.
These declared values were obtained by laboratory type
testing in accordance with the stated standards and are
suitable for comparison with the declared values of other tools
tested in accordance with the same standards. These declared
values are not adequate for use in risk assessments and
values measured in individual work places may be higher. The
actual exposure values and risk of harm experienced by an
individual user are unique and depend upon the way the user
works, the workpiece and the workstation design, as well upon
the exposure time and the physical condition of the user. We,
Chicago Pneumatic, cannot be held liable for the
consequences of using the declared values, instead of values
re lecting the actual exposure, in an individual risk assessment
in a work place situation over which we have no control.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
INSTRUCTION MANUAL
Machine Type:
Power tool with .401 in. shank for use with chisel and various
.401 in. accessories. - No other use is permitted
Air Supply Requirements
1. Supply tool with 90 psig (6.3 bar) of clean, dry air. Higher
pressure drastically reduces tool life.
2. Connect tool to air line using pipe, hose and tting sizes
shown in the diagram below.
Lubrication
1. Use an air line lubricator with SAE #10 oil, adjusted to
two (2) drops per minute. If an air line lubricator cannot be
used, add air motor oil to the inlet once a day.
2. The use of synthetic oils for air line lubrication is not
recommended because of possible damage to seals,
o-rings, hose, rotor blades and polycarbonate oiler/lter
bowls.
Operation
1. To insert chisel, press loop on retainer aside, push chisel
into cylinder and release loop.
2. Place cutting edge of chisel against workpiece, depress
trigger.
Caution: Do not operate tool without chisel in
cylinder, or allow the chisel to be driven out of cylinder.
Internal damage will result if piston is allowed to strike
cylinder wall.
Maintenance
1. Disassemble and inspect tool every three months if the tool
is used every day. Replace damaged or worn parts.
2. High wear parts are underlined in the parts list.
3. Dirt or gum deposits cut tool power. To correct this, ush
out the tool with gum solvent oil. If outside conditions are
in order, disassemble tool, replace worn or damaged parts,
clean, reassemble and relubricate.
1/2" (12 mm)
3/8" (10mm)
3/8" (10mm)
3/8" (10mm)
CA048361 (1/2")
CA048362 (1/2")
CA048360 (1/2")
3/8" (10mm)
3/8" (10mm)
Learn more about air tools and compressors on our website.
