Citizen 0S2A User manual

CHRONOGRAPH FUNCTION: CENTER CHRONOGRAPH SECOND HAND 1/1 sec.
Timing up to 59 minutes 59 seconds.
A) DISPLAYS AND BUTTONS
B) SETTING THE TIME
C) SETTING THE DATE
D) USING THE CHRONOGRAPH
E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY)
A) DISPLAYS AND BUTTONS
B) SETTING THE TIME
1. Pull the crown out to the 2nd position.
2. Turn the crown to set hour and minute hands.
3. When the crown is pushed back to the normal position, small second hand begins to run.
Cal. 0S2A/0S2B/0S2F Instruction manual
Chronograph
second hand
Hour hand
Chronograph
minute hand
minute hand
Button A
24 hour hand
1st position
2nd position
Nomal crown position
Calendar
Button B
Small Second
1/3

C) SETTING THE DATE
1. Pull the crown out to the 1st position.
2. Turn the crown counter-clockwise to set the date.
*If the date is set between the hours of around 9:00 PM and 1:00 AM,
the date may not change on the following day. crown back to the normal position.
3. After the date has been set, push the crown back to the normal position.
D) USING THE CHRONOGRAPH
This chronograph is able to measure and display time in 1/1 second united up to
maxinum of 59 minutes 59 seconds.
The chronograph second hand keeps continuously for
59 minutes 59 seconds after starting. Measuring time with the chronograph
Measuring time with the chronograph
1. The chronograph can be started and stopped each time button "A" is pressed.
2. Pressing button "B" resets the chronograph and the chronograph second hand and
chronograph minute hand return to zero position.
RESET
TIME
MEASUREMENT
STOP
"A"
"B"
"A"
"A"
"B"
2/3

E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY)
This procedure shoud be performed when the chronograph second hand does not return to
zero position after the chronograph has been reset,
and including after the battery has been replaced.
1. Pull the crown out to the 2nd position.
2. Press button "A" to set the chronograph second hand to the zero position.
The chronograph hand can be advanced rapidly by continuously pressing button "A".
3. Once the hand have been zeroed, return the crown to the normal position.
* Do not push crown to normal position while the chronograph second hand returns to
zero position.
It stops on the way when crown are returned to normal position and its position is
recognizedas zero position.
These specifications might be changed without prior notice.
3/3