YOUR CLARISONIC
The Clarisonic sonic technology works with the
natural elasticity of your skin to provide deep,
thorough, gentle daily cleansing. Cleansing is
the foundation of a complete skin care ritual.
Oscillating back and forth at a sonic frequency
that produces 300 movements per second, a
flexing action is created between the outer and
inner brushes that works deep within the pores
to gently loosen dirt and oil. The brush motion
effectively cleans, clarifies and stimulates,
resulting in smoother and softer feeling and
looking skin.
TO USE
Prior to the first use, charge the Clarisonic
handle for 24 hours.
If you use makeup, remove eye makeup by
hand.
Wet your skin and the brush head with warm
water.
Liberally apply cleanser to your skin or to the
brush head. Push the on/off button to turn
your Clarisonic on and gently move the brush
using a small circular motion, beginning on the
forehead, then moving to the nose/chin area
and the cheeks at the T-timer™prompts.
Pressing too hard will impede the motion of the
brush and reduce its effectiveness. The outer
brushes are designed to contain any residual
mist from the brush oscillation, so be sure to
hold the brush head flush to your skin.
The Clarisonic handle is waterproof and may
be used in the shower or bathtub. Refer to
Important Safeguards regarding the charging
cradle.
CUSTOMIZING YOUR CLARISONIC
The Clarisonic is packaged with the Sensitive brush head (white base)
installed. We also offer optional brush heads for different skin types.
Your Clarisonic is programmed to operate in a variety of power settings
and brushing durations. The factory setting is low power for one minute.
POWER LEVEL
The Clarisonic PRO offers a choice of 3 power levels: high, normal and
low. Power level is indicated both audibly and visually. To change the
power level, press the power level button while the Clarisonic is on.
Power level Audible indication Visible indication
High 5 ascending beep s both red lights on
Normal 3 ascending beeps upper red light on
Low 3 descending b ee ps lower re d light on
CLEANSING TIMER (T-TIMER)
For even and thorough cleansing of your face, the Clarisonic features a
proprietary one-minute T-timer that beeps and pauses momentarily to
indicate it is time to move to another part of your face. We recommend
20 seconds on your forehead, 20 seconds on your nose/chin, and 10
seconds on each cheek.
The T-Timer settings are indicated by three different audible sequences.
To change the setting, press and hold the on/off button for 2 seconds.
To change to a different setting, release the on/off button, then press
and hold.
Audible indication Cleansing duration T-TIMER™ beeps
1 long beep & 2 minutes at 40, 80, a nd 100
2 short beeps seconds
1 long beep only 2 minutes none
1 long beep & 1 minute (this i s factory at 20, 40, and 50
1 short beep selec ted default) second s
To pause the cleansing cycle for up to 30 seconds, simply press the on/
off button. The red light(s) flash in pause mode. To resume, press the
on/off button.
Cleanse your face using
our T-timer recommended
duration and zones as
shown above.
forehead
20
seconds
nose/
chin
20
seconds
each
cheek
10
seconds
Gently move the brush using
a small circular motion.
E
F
D
A
A
B
C
D
E
F
HANDLE
BRUSH HEAD (Sensitive)
ON/OFF BUTTON
POWER LEVEL BUTTON
CHARGING CRADLE
CHARGE INDICATOR
C
B
pushdown 1
pullaway 2
…
a
n
d
t
w
i
s
t
CARING FOR YOUR CLARISONIC
To keep your Clarisonic in optimum condition, care for it as follows.
Do not use abrasive cleaners or chemicals to clean any part of the
Clarisonic. Do not put any part of the Clarisonic in a dishwasher.
HANDLE
Once a week wash the handle using warm soapy water to remove
any residue buildup. The handle is sealed and fully waterproof. Never
attempt to open the brush handle for any reason.
CHARG ING CRADLE
IMPORTANT: Unplug the charging cradle before you clean it. After
unplugging the cradle, wipe it with a soft, damp cloth. Do not immerse
the charging cradle in water.
BR USH H EADS
We recommend that the Clarisonic brush heads
be replaced every 90-120 days as the bristles
become fatigued and less effective over time.
Once a week, remove the brush head from the
handle and rinse with warm soapy water to
remove any residue.
To remove the brush head, 1 grip the brush
head firmly, then push and twist it counter-
clockwise (like a medicine cap). 2 Pull the head
away from the handle.
To attach the brush head, push down and twist
the head clockwise until it snaps into place. Be
sure you hear a tight snap.
TIP: Use the brush head cap to easily remove
and attach the brush head with a simple twist.
Purchase additional or replacement brush
heads from your skin care professional,
physician, medi-spa or Clarisonic retailer. Or
call 888-525-2747 or visit clarisonic.com.