HiB Alpine 50 User manual

T: [phone] F: [phone] E: [e-mail] hib.co.uk
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the
interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.
This product is IP44 rated and is suitable for installation in
zones:
FI#01 017 R191121 Ver No. 3.0 Jan 2020
2 &Outside Zone
All installations must comply with guidelines which are based on a zonal
concept. The diagram above illustrates this concept and must be followed
to ensure the safe installation of electrical appliances in the bathroom. These
regulations apply to domestic installations only. HiB recommends that all
electrical bathroom products must be installed in accordance with
current building and wiring regulations. If in doubt please contact
an electrician.
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to
them during installation to ensure that your product is fitted safely and
that it retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply
to which the mirror is to be connected is turned off. Before
drilling, ensure that there are no hidden cables or pipes in the
wall.
(Fig. 1)
Mounting Points Diagram (Fig. A)
Installation
1. Position the mirror in a suitable location (according to the zonal
diagram - Fig. 1), ensuring that the domestic electrical mains
supply is within reach of the electrical entry point of the product.
2. Carefully mark the position of the mirror using a so pencil
ensuring it is level. Remove the mirror and mark the mounting
points. Please ensure that all marked mounting points
accurately match up with the fixing points on the mirror.
3. Using a suitable drill bit, drill holes in the marked positions to a
suitable depth. If drilling through tile, use a ceramic drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting to a tiled
surface, wall plugs should be inserted below the tile surface to
avoid cracking. NB. For plasterboard walls, specialist fixings should
be purchased, available from any DIY or hardware store.
5. Screw supplied fixings into wall plugs.
6. Ensure the domestic electrical mains supply to which the
mirror is being connected is turned off. Connect the domestic
mains supply to the terminal box according to the wiring diagram
(Fig. B) overleaf.
7. Hang the mirror in position.
8. Switch the domestic electrical mains supply for the mirror back on.
NB. LED Mirrors with charging socket only; On first use of the charging
socket, there may be resistance when inserting the plug. Make sure
that the mirror is held firmly so that it is not pushed off the wall. Aer a
few uses, resistance will ease and the socket will function as normal.
mounting points
REAR VIEW
Hanging Portrait
Hanging landscape
Operation Instructions
Alpine/ Arena / Vega - To turn illumination on or off, press the touch
sensor. To cycle through warm to cool colour temperature, press and
hold the touch sensor - release when the desired colour temperature
has been reached. Heated Pad is only on when mirror is illuminated.
Globe / Duplus - To turn illumination on or off, wave hand past
the sensor on the side/bottom of the mirror. To alter the colour
temperature, hold your hand over the sensor, remove hand when the
desired colour temperature has been reached. Heated Pad is only on
when mirror is illuminated.
NB. Globe / Duplus mirrors must be installed with a minimum distance
of 150mm between the infra-red sensor switch and any adjacent wall or
object to ensure correct operation of the sensor.
WEEE compliance
Must not be mixed with general household waste
Note: Globe / Arena are dual orientation. Alpine,Duplus and Vega are
xed orientation.
Alpine 50
Alpine 60
Alpine 80
Alpine 100
Arena 80
Arena 120
Duplus 50
Duplus 60
Duplus 80
Globe 45
78753000
78754000
78755000
78756000
79530800
79531200
78727000
78728000
78729000
78400000
Globe 50
Globe 60
Globe 90
Globe 120
Globe 140
Vega 40
Vega 50
Vega 60
Vega 80
Vega 120
78500000
78600000
78640000
78700000
78710000
78749000
78750000
78751000
78752000
78748000
Name Art No.
Illuminated Mirrors
Art No.Name

T: [phone] F: [phone] E: [e-mail] hib.co.uk
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the
interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.
Caution
We recommend that you place this mirror on a so flat surface to ensure no breakages.
We also recommend that you leave corner protectors on until final fitting.
live
earth
neutral
MAINS SUPPLYLUMINAIRE
Wiring Diagram
Live supply can be Red or Brown
Earth supply is Green and Yellow
Neutral supply can be Blue or Black
Live is Brown
Earth is Green and Yellow
Neutral is Blue
Wiring Diagram (Fig. B)
Care Instruction
Do not use abrasives or solvents when cleaning this product. Wipe off
all water spillages as soon as possible using a so, damp cloth.
Aercare Service
In the unlikely event that this product should fail please contact HiB
customer services, details shown below. Wipe off all water spillages as
soon as possible using a so, damp cloth.
CAUTION