Clarke CONTRACTOR WB85P User manual

USER INSTRUCTIONS
ORIGINAL INSTRUCTIONS DL1121 ISSUE 2
85 LITRE WHEELBARROW
MODEL NO: WB85P
PART NO: 6603110

2
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
INTRODUCTION
Thank you for purchasing this CLARKE 85 Litre Wheelbarrow.
Before attempting to operate the product, it is essential that you read this manual
thoroughly and carefully follow all instructions given. In doing so you will ensure the
safety of yourself and that of others around you, and you can also look forward to the
product giving you long and satisfactory service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12 months
from the date of purchase. Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with
in any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product can be
returned to us without prior permission.
This guarantee does not effect your statutory rights.
TECHNICAL SPECIFICATIONS
Unpack the components onto a clean flat area and ensure that all parts are present
according to the components list.
Visually inspect all components to ensure that no damage was suffered in transit. Any
deficiencies should be reported to your CLARKE dealer immediately.
WB85P
Capacity 85 Litres
Sand Capacity 5.5ft3
Wheel Diameter 350mm
Weight 12kg

3
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
COMPONENTS
1 1 x Wheel 6 1 x Bucket Support Bar
2 1 x Front Frame Section 7 1 x Wheel Axle
3 2 x Rear Frame Handles 8 2 x Wheel Supports
4 1 x Bucket 9 6 x Large Bolt, Nut & Washers
5 2 x Front Support Bars 10 6 x Small Bolt, Nut & Washers

4
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
ASSEMBLY
NOTE: Hand tighten all bolts & nuts until the product is fully assembled.
1) Insert the rear frame handles (3) into the
front frame section (2), aligning the holes
and secure with a large bolt, nut &
washers (9)
2) Fix the bucket support bar (6) between
the rear frame handles (3) using a large
bolt, nut & washers (9)
3) Align the bucket (4) against the frame.
Secure the bucket to the frame using the
small bolts, nuts & washers (10) through the
4 holes in the bottom of the bucket.
4) Attach the front support bars (5) to the
remaining holes in the bucket using the
small bolts, nuts & washers (10).
* = The right angle side should fit against
the frame, do not attach at this stage.
5) Using a large bolt, nut & washers (9),
thread the bolt through the front support
bar (5), the frame and the wheel support
(8) and secure with the nut. Only do this for
one side.
6) Fix the axle (7) through the wheel (1).
Slide the axle into the wheel support (8)
secured to the frame. Fit the second wheel
support, making sure the wheel and axle
are supported on both sides before fixing
with a nut. Tighten all bolts and nuts fully.