Clarke Air 25CN Installation and operation manual

Blow Gun
Model : 25CN
Part No : 3090150
OPERATING & MAINTENANCE
INSTRUCTIONS
0303
WARNING
Compressed air can be
dangerous. Ensure that you are
thoroughly familiar with all
precautions relating to the use
of compressors and
compressed air supply.
CLARKE GUARANTEE
This CLARKE product is guaranteed against faulty manufacture
for a period of 12 months from the date of purchase. Please keep
your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been
abused or tampered with in any way, or not used for the pur-
pose for which it was intended.
Faulty goods should be returned to their place of purchase, no
product can be returned to us without prior permission.
This guarantee does not affect your statutory rights.
Please read these instructions carefully before operating the tool
Thank you for purchasing this CLARKE Blow Gun
Before using the device, please read this manual thoroughly and carefully
follow all instructions given. This is for your own safety and that of others
around you, and is also to help you achieve long and trouble free service
from your new blow gun.
This simple to operate trigger action
blow gun can be used to blow away
dust and wood shavings as well as metal
filings and swarf.
Take great care when using this
appliance... DO NOT use high air
pressure when cleaning dust from
electrical or electronic components.
Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change
specifications at any time without prior notice.

Accessories
A wide range of airline accessories is available from your nearest CLARKE dealer, for further information, contact your nearest dealer, or telephone CLARKE International Sales department on
01992 565300.
PARTS & SERVICE TEL: [phone]
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
Maintenance
IMPORTANT
Disconnect the gun from the air supply,
and relieve any pressure in the gun
and hose, before any disassembly.
The only maintenance other than to replace
worn or broken parts, is to keep the gun
clean and lubricated.
Occasionally clean the gun and lubricate
all moving parts, especially the trigger stud.
Inspect the gun and air hose for wear or
damage periodically, and replace if
necessary.
DO NOT use damaged or leaking hoses.
Specifications
Model: ...................................... 25CN
Part No: .................................... 3090150
Air Inlet Connector: ................ ¼”BSP
Minimum Compressor Size: .... 0.65HP
ALWAYS wear a suitable approved breathing mask, to protect against inhalation
of dust or fumes.
ALWAYS wear approved impact resistant safety goggles. Eye glasses are NOT
safety glasses.
ALWAYS disconnect the gun from the air supply when it is not in use, and before
any disassembly.
NEVER point gun towards people or animals. In the case of injury, seek expert
medical advice immediately.
NEVER allow children to use or play with this appliance.
SAFETY PRECAUTIONS
For your personal safety and that of others around you. Follow these
safety instructions carefully.
Blow guns should only be connected to an
airline precedded by a pre-set tamper-
proof pressure regulator set at a reduced
pressure from the normal 80 psi airline
supply.
If in any doubt, please contact your
nearest Clarke service department.
The air supply should be completely cllean
and dry.
Lubricators of any kind should not be used
with blow guns.
WARNING
WARNING
Compressed air can be
dangerous. Ensure that you are
thoroughly familiar with all
precautions relating to the use of
compressors and compressed air
supply.