Clarke CHT718 User manual

USER INSTRUCTIONS
GC06/12
UNIVERSAL HUB/BEARING
PULLER
Model No: CHT718
Part No: 1801718

2
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
INTRODUCTION
Thank you for purchasing this CLARKE product. The kit may be used for
installing seals and bearings into the hubs of most vehicles. It may also be
used for pulling hubs where the wheel flange is drilled and tapped so that the
road wheel is secured with bolts.
Please read and follow the instructions carefully. In doing so you will ensure
the safety of yourself and others around you, and you can look forward to
the product giving you long & satisfactory service.
Please keep these instructions in a safe place for future reference
KIT CONTENTS
A Sleeve 76mm (3”) HTCHT71810
B1 Cup- 86mm (3-13/32”) HTCHT71811
B2 Cup- 91mm (3-19/32”) HTCHT71812
C1 Bolt M14 x 90 HTCHT71813
D Flat Washer HTCHT71814
E Sleeve 36mm (1-7/16”) HTCHT71815
F Centre Bolt HTCHT71816
G Thrust Washers HTCHT71817
H Long Nut HTCHT71818
C2 Bolt M12 x 90 HTCHT71819
1 Disc - 55.5mm (2-3/16”)HTCHT71801
2 Disc - 59mm (2-11/32”) HTCHT71802
3 Disc - 62mm (2-7/16”) HTCHT71803
4 Disc - 65mm (2-9/16”) HTCHT71804
5 Disc - 66mm (2-19/32”) HTCHT71805
6 Disc -71.5mm (2-13/16”)HTCHT71806
7 Disc - 73mm (2-7/8”) HTCHT71807
8 Disc - 78mm (3-3/32”) HTCHT71808
9 Disc - 84mm (3-5/16”) HTCHT71809

3
Parts & Service: 020 8988 7400/E-mail:Part[email protected] or [email protected]
METHOD OF USE
WARNING: THE VEHICLE MUST BE PROPERLY PREPARED, AND
ADEQUATELY SUPPORTED ON AXLE STANDS, ON FIRM LEVEL GROUND,
BEFORE ANY OPERATION USING THIS TOOL IS PERFORMED.
INSTALLING SEALS & BEARINGS
Assemble the parts as shown in the example, selecting the components
which fit the job in hand. Ensure the large nut (H) is screwed fully on to the
bolt (F), and all components are entirely square before tightening.
HUB PULLING
It is possible to remove a hub from the swivel joint,
using the bolts (C) supplied.
The appropriate size bolts are screwed into the holes
in the wheel flange, so that they bear up against
the surface of the swivel joint.
Screw in the bolts progressively to pull off the hub.
For hubs where the wheel is mounted on studs, a
slide hammer type puller must be used.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for its intended purpose. Faulty goods
should be returned to their place of purchase. No product can be returned
to us without prior permission. This guarantee does not effect your statutory
rights.