Clarke RWL30 User manual

OPERATING INSTRUCTIONS
GC01/12
30 LED Rechargeable Worklight
Model No: RWL30
Part No: 4002830

2
Parts & Service: 020 8988 7400/E-mail:Part[email protected] or [email protected]
DECLARATION OF CONFORMITY

3
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
INTRODUCTION
Thank you for purchasing this CLARKE product. Before using the worklight, be
sure to read these instructions thoroughly. In doing so you will ensure the
safety of yourself and of others around you, and you can look forward to the
product giving you long and satisfactory service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase. This guarantee is invalid if the product is found to have been
abused or tampered with in any way, or not used for its intended purpose.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect
your statutory rights.
PACK CONTENTS
1 x 30 LED Worklight 1 x AC Mains Adaptor/Charger Assembly
1 x 12 Volt DC Charging Adaptor (car cigarette lighter plug type)
BATTERY CHARGING AND CARE
1. Always use only the charging adapters supplied. The mains charger is for
indoor use only. The worklight should only be re-charged when switched
off. Never turn the light on while charging as this may damage the unit.
2. When charging a low battery using the adaptor/charger, the red LED
beside the charging jack will initially illuminate, before changing to the
Green LED when the unit is sufficiently charged for continued use.
3. The battery must be re-charged at least every three months. Failure to
recharge the battery will lead to reduced performance of the worklight
and to premature battery failure. Note that the batteries cannot be
replaced.
4. If you plan to store the worklight (e.g. for emergencies), we recommend
that the battery is fully charged before doing so, this will ensure the longest
possible battery life.
5. Never abuse the charger cable or yank the cable to disconnect it. Keep
the cable away from sharp edges/hot surfaces.
6. Never point the light directly at the face of another person or an animal.
AC CHARGING
1. Connect the AC charging adaptor to the charging jack of the worklight.
2. Connect the other end of the charger to the 230v mains power supply
and charge for approximately 1 hour.
•The worklight must NOT be operated when using the AC charger.

DC CHARGING
1. Connect the DC charging adaptor to the charging jack of the worklight.
2. Connect the other end of the charger to the vehicle cigarette lighter
socket and charge for approximately one hour.
OPERATION
1. Press the on/off button to switch on the worklight.
• Up to 3 hours of light can be obtained before the batteries are
drained.
2. Press the on/off button again to switch the worklight off.
3. Attach the worklight to a suitable support using the folding hook or attach
to a ferrous metal surface using the magnetic retainer.
4. Never shine the light directly into anyones eyes.
CLEANING
To keep your worklight clean, wipe with a damp cloth only, DO NOT use
detergents, chemicals or harmful abrasives. Never immerse in water.
ENVIRONMENTAL PROTECTION
Do not dispose of this product with general household waste. All tools,
accessories and packaging should be sorted, taken to a recycling
centre and disposed of according to the laws governing Waste
Electrical and Electronic Equipment.
Parts & Service: 020 8988 7400/E-mail:Part[email protected] or [email protected]