Coaster 105365 User manual

105365
SERVER WITH SLIDING DOOR
www.coastercompany.com
COASTER FINE FURNITURE
ASSEMBLY INSTRUCTIONS
PAGE 1 OF 5
REVISION 0 : 10/16/2014
REVISION 1 : 12/01/2014

2. Please check to see that all hardware and part are present prior to start of assembly.
2. This product is for home use only and not intended for commercial establishment.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
1. Remove hardware from plastic bag and sort by size.
PARTS IDENTIFICATION:
C
B
A
immediately.
ASSEMBLY TIPS :
105365
Warning !
ITEM :
PAGE 2 OF 5
www.coastercompany.com
SHELF
LEG
SERVER
2PCS
ASSEMBLY INSTRUCTIONS
HARDWARE IDENTIFICATION:
1PC
4PCS
3
5
6
4
2
1
PULL
ALLEN WRENCH
2PCS
7
SCREW 4PCS
1PC
LOCK WASHER
SHELF SUPPORT
FLAT WASHER
BOLT
8PCS
8PCS
8PCS
8PCS
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS. HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.

www.coastercompany.com
PAGE 3 OF 5
105365
ITEM :
STEP 1
ASSEMBLY INSTRUCTIONS
Align and fasten leg (B) to server (A) using bolt (2), lock washer (3) and flat washer (4) and fully tighten with Allen
wrench (1).
4
1
2
3
B
A
STEP 2
Place server (A) upside down on soft surface. Unscrew the L-bracket from the back of door (which is used to secure the door
in place) using Allen wrench (1) .
A
Anti-Tipping Kit is
stapled at the back
panel.
1

ASSEMBLY INSTRUCTIONS
PAGE 4 OF 5
Flip over the server using two people to lift and flip. Align and fasten pull (5) to the doors using screw (6) and fully tighten
with Phillips head screw driver (Not provided).
105365
STEP 3
ITEM :
www.coastercompany.com
4.1. Insert shelf support (7) into the pre-drilled holes of center panel and side panel .
4.2. Align and place shelf (C) onto shelf support (7).
STEP 4
5
6
7
C
C
4.1
4.2

PAGE 5 OF 5
ANTI - TIPPING KIT
www.coastercompany.com
PARTS IDENTIFICATION: HARDWARE IDENTIFICATION:
DSERVER 1PC 8SHORT SCREW 1PC
9LONG SCREW 1PC
10 CABLE TIE 1PC
11 L BRACKET 2PCS
STEP 2
STEP 1
This tip restraint must be attached to a wall
stud using long screw enclosed.
Attach a bracket securely to the back top rail of server using
short screw provided, through the smaller hole.
Locate the other bracket on the wall over a wall stud and two
inches below the mounting bracket secured to the back of
server. Attached to the wall stud using the long screw
provided, through the smaller hole.
8WALL
D9
11
11
STEP 3
Place the server into position so both mounting brackets are vertically in line. Lace the end of the cable tie through the larger
hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it though
until all slack is removed. Confirm that the cable is securely laced and locked.
WALL
10