Coaster 203331Q User manual

REVISION 0 : 10/01/2013
PAGE 1 OF 4
203331Q (B1 & B2)
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
QUEEN SIZE PU BED

ITEM :
ASSEMBLY INSTRUCTIONS
A1 PC E
BED SLAT SUPPORT
2 PCS
WITH LEVELER
F
BED RAIL
2 PCS
B2 PCS
G
CENTER RAIL
1 PC
C28 PCS HB 1 PC
D1 PC
D1 PC
1
SHORT BOLT 2 PCS
4
5
SCREW 2 PCS
2
LONG BOLT 2 PCS
6
1 PC
3
7
1 PC
www.coastercompany.com
PAGE 2 OF 4
PARTS IDENTIFICATION
HARDWARE IDENTIFICATION
203331Q (B1)
*FROM BOX 1
HEADBOARD
COMPLETE
203331Q (B1)
*FROM BOX 1
FOOTBOARD
HEADBOARD PANEL
FOOTBOARD
B2 (BOX 2)
203331Q (B1 & B2)
B1 (BOX 1)
BIG ALLEN
WRENCH
BED SLAT
HEADBOARD LEG
Z - B2 (BOX 2) - Hardware pack is located in 203331Q (B2)
SMALL PLASTIC
CONNECTOR 28 PCS
LARGE PLASTIC
CONNECTOR 14 PCS
SMALL ALLEN
WRENCH
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment.

ASSEMBLY INSTRUCTIONS
www.coastercompany.com
STEP 3
STEP 1
STEP 2
PAGE 3 OF 4
ITEM : 203331Q (B1 & B2)
203331Q (B1) - BOX 1
Place headboard panel face downward on a soft surface to prevent it from scratching.Align and fasten headboard
legs to the bottom of the headboard panel using long bolt and tighten with small Allen wrench.
203331Q (B1 & B2) - BOX 1 & BOX 2
Align and fasten bed slat support with leveler to center
rail using short bolt and tighten with small Allen
wrench.
Align and fasten bed rail to headboard and footboard
using long bolt and tighten with big Allen wrench.
G
E
7
1
6
D
F
HB
B
7
2
A

ASSEMBLY INSTRUCTIONS
www.coastercompany.com
Press to fix the pin of the plastic connector into the holes at the center rail and bed rail. Light tap with a rubber
mallet (NOT INCLUDED). May need to fully insert the pin of the plastic connector into the holes (as shown in the
drawing below).
Complete
STEP 6
PAGE 4 OF 4
ITEM :
STEP 5
STEP 4
Align and slot in center rail to the metal bracket at
the center of headboard and footboard. Then adjust
leveler to touch the floor.
203331Q (B1 & B2)
Join two pieces of bed slat together using large plastic
connector. Push to fix two pieces of small plastic
connector to both ends of bed slat (as shown in the
drawing below).
3C
4C
3
C
3
4
C
F
D
HB
F
D
E
G
5
HB