Coaster 122256 User manual

R
FINE FURNITURE
122256
CONSOLE SERVER
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
PAGE 1 OF 5
www.coastercompany.com
REVISION 0 : 03/03/2017

R
FINE FURNITURE
ASSEMBLY TIPS :
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly
3. Please follow attached instruction in the same sequence as numbered to assure fast and easy assembly.
WARNING !
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately
2. This product is for home use only and not intended for commercial establishment.
PARTS IDENTIFICATION
A. SERVER 1 PC
ASSEMBLY INSTRUCTIONS
B. SERVER LEG 4 PCS
www.coastercompany.com
ASSEMBLY TIME 20 MINUTES
PAGE OF2 5
ITEM : 122256

R
FINE FURNITURE
www.coastercompany.com
COMPLETE
ASSEMBLY INSTRUCTIONS
STEP 1
PAGE OF3 5
B
A
A
B
B
B
B
ITEM : 122256

PAGE 4 OF 5
R
FINE FURNITURE
OPTIONAL ADJUSTABLE SHELF
www.coastercompany.com
STEP 1
To remove the shelf, unscrew the shelf from shelf support using Phillips head screw driver ( NOT INCLUDED ).
STEP 2
Adjust the height of shelf support.
STEP 3
Align and fasten shelf support to shelf using screw and fully tighten with Phillips head screw driver
( NOT INCLUDED ).
PROCESS; HOWEVER MANUFACTURER DOES NOT PROVIDE THIS ITEM.
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
STEP 1
STEP 2
STEP 3

PAGE 5 OF 5
R
FINE FURNITURE
ANTI - TIPPING KIT
PARTS IDENTIFICATION
www.coastercompany.com
A. 1 SET
HARDWARE IDENTIFICATION
1. SHORT SCREW 1 PC
2. LONG SCREW 1 PC
3. CABLE TIE 1 PC
4. L BRACKET 2 PCS
This tip restraint must be attached to a wall
stud using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail
of the console server using short screw provided,
A
4
1
STEP 2
Locate the other bracket on the wall over a wall stud
and two inches below the mounting bracket secured to
the back of console server. Attached to the wall stud using
the long screw provided, through the smaller hole.
through the smaller hole.
2 4
STEP 3
Place the console server into position so both mounting brackets are vertically in line. Lace the end of the restraint strap
through the larger hole in each mounting bracket. Bring both ends together and slide the flat end through the
locking end and draw it through until all slack is removed. Confirm that the strap is securely laced and locked.
4
43
WALL
WALL
CONSOLE SERVER