Coaster 203503 User manual

DRESSER AND MIRROR
203503 & 203504
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
R
PAGE 1 OF 4 REVISION 0 : 05/16/2014

ITEM : 203503 & 203504
HARDWARE IDENTIFICATION
PAGE 2 OF 4
ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION
A
B
1PC
1PC
C
A
B
C2PCS
MIRROR
DRESSER
MIRROR SUPPORT
(PACKED WITH DRESSER)
10PCS
FLAT HEAD SCREW
1
1.Remove hardware from box and sort by size.
2.Please check to see that all hardware and parts are present prior to start of assembly.
3.Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
1.Don't attempt to repair or modify parts that are broken of defective. Please contact the store
2.This product is for home use only and not intended for commercial establishment.
Warning!
immediately.
ASSEMBLY TIPS:
www.coastercompany.com

PAGE 3 OF 4
ASSEMBLY INSTRUCTIONS
STEP 2
STEP 1
**BACK VIEW
ITEM : 203503 & 203504
MAKE SURE ARROW
MARKING IS ALIGNED
A1
A
B
C
C
B
Place the mirror (A) on top of dresser (B).Then adjust the arrow mark on the center of mirror (A) aligned with the arrow
mark on the center of dresser (B). Align and fasten mirror support (C) to mirror (A) using flat head screw (1) and
tighten with screw driver (not included).
**BACK VIEW
Cut off the string that secures the mirror supports (C).[Pre-installed at the back of dresser (B)].Turn the
mirror supports (C) upright.
www.coastercompany.com

PAGE 4 OF 4
ASSEMBLY INSTRUCTIONS
STEP 3
Align and fasten mirror support (C) to dresser (B) using flat head screw (1) and tighten with screw driver (not included).
ITEM :
1
Arrow Marking
Must
Be Aligned
C
203503 & 203504
STEP 4
www.coastercompany.com