Coaster 950365 User manual

950365
ACCENT CABINET
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 2 REVISION 0 : 08/07/2015

A1PC 1 L-BRACKET 2PCS
2 CABLE TIE 1PC
3 LONG SCREW 1PC
4 SHORT SCREW 1PC
5 PLASTIC ANCHOR 1PC
1.1 Attach one of the mounting brackets securely to the back edge of the cabinet. Use the short screw.
1.2 Determine where the cabinet is to be placed and mark location on the wall for the mounting bracket
screw hole approximately 2" below the bracket mounted on the edge of the cabinet.
1.3 Drill a 3/16" hole in the wall. Press the plastic anchor into the hole and gently tape until the flange on the
anchor is against the wall surface.
1.4 Position the bracket over the anchor and use the long screw to securely attach the bracket to the wall.
1.5 Place the cabinet so the bracket on the back edge is in line with the bracket on the wall.
1.6 Lace an end of the cable tie down through each bracket. Bring both ends together and slide the beaded end
of the cable tie through the keyhole shaped slot on the other end until snug. Pull down on the beaded end
until it snap locks into the keyhole slot.
1.7 To double lock return the beaded end back through the keyhole as shown.
1.8 Check to make sure the cable tie is securely laced and locked to the brackets.
www.coastercompany.com
ANTI-TIPPING KIT
PARTS IDENTIFICATION
ACCENT CABINET
HARDWARE IDENTIFICATION
PAGE 2 OF 2
A