Coaster Simpson 110185 User manual

ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
Fine Furniture for every stage of life
110185
Server
REVISION 0 : 10/10/2019 PAGE 1 OF 2 COASTERFURNITURE.COM

1. Attach one of the mounting brackets securely to the back edge of the furniture. Use the short
screws.
2. Determine where the furniture is to be placed and mark location on the wall for the mounting
bracket screw hole approximately 2" below the bracket mounted to the edge of the furniture.
3. Drill two 3/16" holes in the wall. Press the plastic wall plugs into the holes and gently tap until the
flanges on the wall plugs are against the wall surface.
4. Position the bracket over the wall plugs and use the long screws to securely attach the bracket
to the wall.
5. Place the furniture so the bracket on the back edge is in line with the bracket on the wall.
6. Lace an end of the cable tie down through each bracket. Bring both ends together and slide the
beaded end of the cable tie through the keyhole shaped slot on the other end until snug.
Pull down on the beaded end until it snap locks into the keyhole slot.
7. To double lock return the beaded end back through the keyhole as shown.
8. Check to make sure the cable tie is securely laced and locked to the brackets.
COASTERFURNITURE.COM
ITEM:
ANTI-TIPPING INSTALLMENT INSTRUCTIONS
Failure to detach this restraint before moving the furniture may result in injury and damage.
FURNITURE TIPPING RESTRAINT
WARNING
Injury may result from tipping furniture.
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult supervision.
PAGE 2 OF 2
110185

ITEM:110185
COASTERFURNITURE.COM
69.00" 18.00"
31.00"
37.00"
19.75"
14.50"
11.50" 30.50"
9.50"
16.00"
6.50"
36.00"
27.50"
18.00"
Note : Dimension tolerance ±5%
7.00"