Cochlear D1887457 User manual

Aqua+ for Nucleus 7 User
Guide - Multilingual - Thai -
APAC
D1887457
Version: 1
State: Released
Approver: Andrei Ciobanu (aciobanu)
Date : 19 Aug 2021
Document Control Note: Hardcopies of this document
are non-controlled unless the relevant Transmittal Advice
Notification (TAN) information is stamped in the box below.
Number of pages (include Coversheet): 45

Nucleus®7 Aqua+
User Guide
CP1000
D1887457_1-03_Aqua-CP1000_APAC.indb 1 8/6/2021 5:45:25 PM

Contents
Cochlear™ Nucleus® 7 Aqua+ —
Instructions
1
Cochlear™ Nucleus® 7 Aqua+ —
คำ�แนะนำ� 21
D1887457_1-03_Aqua-CP1000_APAC.indb 2 8/6/2021 5:45:26 PM

1
nucleus®7 aqua+ useR GuIDe
Nucleus®7 Aqua+
Cochlear Nucleus 7
Aqua+
Nucleus Safety Line
(optional)
Cochlear Nucleus
Mic Lock-Stirrup
(optional)
Cochlear Nucleus 7
Aqua+ Coil
D1887457_1-03_Aqua-CP1000_APAC.indb 1 8/6/2021 5:45:28 PM

2
nucleus®7 aqua+ useR GuIDe
The Cochlear™Nucleus® 7 Aqua+ is a re-usable sealable
cover that, when used with the Cochlear Nucleus 7 Aqua+
Coil, keeps your Cochlear Nucleus 7 Sound Processor (model
number: CP1000) dry during use in or around water (e.g. when
swimming, surfing, or just having fun splashing around). It is
worn behind the ear with your sound processor sealed inside.
The Nucleus 7 Aqua+ is intended for use by recipients using
the Nucleus 7 Sound Processor with rechargeable batteries. It
should only be used by recipients who can either remove the
sound processor themselves if it’s causing discomfort or who
can indicate any discomfort to their parent or caregiver.
You must use a Cochlear Standard Rechargeable Battery
Module or Cochlear Compact Rechargeable Battery
Module for your sound processor to work inside Aqua+.
Zinc air batteries will not work as they need air and there is no
air inside Aqua+ when it’s sealed.
The Nucleus 7 Aqua+ Coil is used in place of your usual
coil while your sound processor is inside your Aqua+. It has a
special plug that creates a seal when connected to your sound
processor’s coil socket through the coil plug hole in Aqua+. As
with your usual coil, a coil magnet screws into the Aqua+ coil
and holds it against your implant.
NOTES
• You cannot use your Nucleus 7 Sound Processor in Hybrid™
mode with Aqua+.
• You cannot use your Nucleus 7 Sound Processor with any of
the Cochlear retention accessories (e.g. Snugfit, Hugfit) with
Aqua+.
D1887457_1-03_Aqua-CP1000_APAC.indb 2 8/6/2021 5:45:28 PM

3
nucleus®7 aqua+ useR GuIDe
The Cochlear Nucleus Mic Lock-Stirrup is a retention
option to hold Aqua+ more securely behind your ear. The
stirrup connects to the base of Aqua+ and the Mic Lock tube
(when cut to size) passes under the ear lobe and connects to
the Aqua+ earhook.
The Nucleus Safety Line is a retention option to help prevent
accidental loss of your Aqua+ by securing it to your clothing
with a snap-lock clip.
Remotes, wireless accessories and compatible iOS devices can
be used with Aqua+, however they should be protected from
water and kept dry.
You may notice a difference in sound quality when using
Aqua+.
Testing shows Aqua+ can be used at depths of up to 3 metres
for up to 2 hours.
Testing shows Aqua+ can be re-used up to 50 times, but this
may vary depending on your particular use of it.
There have been no reported undesirable side effects from
using Aqua+.
For more information, refer to the Nucleus 7 Sound Processor
User Guide.
D1887457_1-03_Aqua-CP1000_APAC.indb 3 8/6/2021 5:45:28 PM

4
nucleus®7 aqua+ useR GuIDe
Nucleus 7 Aqua+ instructions
Before you get wet...
TIP
Don‘t forget you must be using rechargeable batteries for your
sound processor to work inside Aqua+.
1. Carefully unplug your
usual coil from the sound
processor. Hold the coil
cable grip and firmly
pull it straight out of the
processor.
CAUTION
Do not pull on the coil
cable or twist when you
pull it out.
2. Insert your sound
processor into Aqua+
(leave your earhook on).
CAUTION
Be careful to avoid
bending the earhook, or
detaching it from the
sound processor.
D1887457_1-03_Aqua-CP1000_APAC.indb 4 8/6/2021 5:45:36 PM

5
nucleus®7 aqua+ useR GuIDe
3. Insert the plug into the
base of Aqua+. To make a
good seal, push the plug
in as far as it will go.
4. Plug the blue Aqua+
coil (with magnet)
straight into your sound
processor through the
hole in Aqua+. Grip the
black ring on the coil
connector. Do not twist.
The coil plug should feel
securely connected.
(See page 10 for magnet
instructions)
D1887457_1-03_Aqua-CP1000_APAC.indb 5 8/6/2021 5:45:40 PM

6
nucleus®7 aqua+ useR GuIDe
5. If you’re concerned about losing your Aqua+, use one of
these retention options:
• Safety Line clips to your
clothing.
(See page 11 for instructions)
• Mic Lock-Stirrup holds
your processor on your
ear.
(See page 12 for instructions)
D1887457_1-03_Aqua-CP1000_APAC.indb 6 8/6/2021 5:45:44 PM

7
nucleus®7 aqua+ useR GuIDe
6. Finally, do the Aqua+ Checklist to make sure you’re ready
to get wet!
Using Blue Aqua+ coil
Aqua+ tightly sealed
Mic Lock-Stirrup or
Safety Line attached if
required
Using rechargeable
batteries
7. Have fun!
D1887457_1-03_Aqua-CP1000_APAC.indb 7 8/6/2021 5:45:46 PM