Coleman CRESTLINE 9277E107 User manual

Connect Frame to Tent
– Insert one pin into the end of main tent
pole at tent corner. (illus. 3, illus. 4)
– Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole end.
– Repeat for second pole.
– Insert pin into the end of side pole, go to
opposite end of pole and apply pressure
until you arch the pole and can insert
the pin into the pole. (illus. 3, illus. 4)
– Repeat for other side pole.
CRESTLINE™9’10”x7’
1Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using the
stake loops. Keep the floor taut.
(Intermediate loops will be staked later.)
– Assemble frame poles by interlocking
shock-corded poles. (four poles)
– Insert the poles into pole sleeves.The
longer black poles should cross forming
an “X” in the middle of tent. The shorter
side grey poles insert into sleeves
running front to back. (illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
– Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
(2) Rainfly Poles
Side poles
(Grey)
Assembled
poles
inserted
through
pole
sleeves
Instructions apply to Part Number 9277E107
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9277E102
Part No. 9277E103
Part No. 9277E104
illus. 3
Insert pin into pole end
Rainfly Part No.
9277E105
(2) Main Tent Poles
(Black)
(2) Side Poles
(Grey)
POLE ASSEMBLY PARTS

3Attach Tent to Frame
Using Frame Clips
– Attach frame clips along the
edges of tent to frame poles.
(illus. 5), (illus. 6)
– Make any adjustments to the
tent corner stakes, if needed.
– Stake out remainder of
intermediate loops.
4
illus. 5 Assembled tent without rainfly.
Note the frame clips located on edge of tent.
illus. 6
Frame clips
illus. 9 Completed tent with rainfly.
illus. 7
illus. 8
Underside
of rainfly
attaches to
frame poles
Grommets for rainfly poles
Rainfly pole
sleeves
Rainfly poles
Guyline
Attach Rainfly
– Assemble rainfly poles by
interlocking shock-corded poles.
– Insert rainfly poles into pole sleeves
located at the center edges of the
underside of rainfly. (illus. 7)
– Drape rainfly over tent frame,
pole side down. Rainfly poles
should cover door and rear window.
– Connect the four elastic loops
with “S” hooks, (found at the
rainfly corners) to the fabric loops
near frame clips. (illus. 8)
– Insert the tips of the rainfly poles
into the grommets on the front and
rear of tent. (See above illus. 5)
– Secure rainfly with attachments
located on underside of fly. (illus. 9)
– Attach and stake out guylines.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN THAILAND
PRINTED IN THAILAND Rev. 7/04
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
• Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAMEAND HEAT SOURCES
AWAY FROMTHISTENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous
contact with any flame source.The application of any foreign substance
to the tent fabric may render the flame-resistant properties ineffective.