Coleman Ridgeview 9271L133 User manual

Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors
facing desired direction. (illus. 1)
– Stake down tent corners,
using the tent stake loops.
Keep the floor taut. (illus. 2)
– Assemble all poles by interlocking
shock-corded poles.
– Insert the longer Center Frame Poles into
Center Pole Sleeves. The poles should cross
forming an “X” in the middle of tent. (illus. 1)
– Insert the shorter Side Frame Poles through the pole
sleeves located at the sides of tent. (illus. 1)
Connect Frame to Tent
– Unzip doors.
– Locate the Pin & Ring Systems on
either side of the front doors and the
corresponding Pin & Ring on the
back side of tent.
– Insert one end of Frame Pole onto
Pin & Ring System on tent stake loop
on either side of the doors. (illus. 3)
– Go to opposite end of pole diagonally
from starting point and gradually
apply pressure to the pole forming
an arch until you are able to insert
the Pin into pole end.
– Repeat for second pole.
– Attach tent frame clips to poles.
13’x13’ Ridgeview
1
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
– Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
(2) Side Tent
Poles
(2) Rainfly Poles
Rainfly Part No. 9271L104
(2) Center Tent
Poles
Door
Door
Instructions apply to Part Number 9271L133
illus. 1
illus. 2 Tent
stake through
stake loop
illus. 4
Center section upright
Part No. 9270L102
Part No. 9271L105
Part No. 9270L103
illus. 3
Ring & Pin System
Center poles Side pole
Side pole
Center poles
Sidepole
Sidepole
POLE ASSEMBLY PARTS

3Raise Ends of Tent
– Insert one end of the Side Frame Pole
onto the Pin & Ring System.
– Repeat for other Side pole.
– Go to opposite end of pole and
gradually apply pressure until pole
arches enough to fit onto Pin.
– Attach Frame clips.
4Attach Rainfly
– Assemble rainfly poles by
interlocking shock-corded poles.
– Insert rainfly poles into pole
sleeves located at the center
edges of the underside of rainfly.
(illus. 7), (illus. 8)
– Drape rainfly over tent, pole side
down. The rainfly poles should
be over the doors of the tent.
– Insert the ends of the rainfly poles
into the grommets on the tent body.
– Secure the underside of the rainfly
to the tent poles.
– Connect the elastic loops
with “S” hooks (found at the
rainfly corners) to fabric loops
near frame clips.
– Attach guylines to fabric loops on
rainfly. Two at each end over side
windows and four on the rainfly.
Stake out guylines away from the
tent at an angle. (illus. 9)
illus. 6
Assembled tent without Rainfly. Note
the Frame Clips located on tent.
illus. 5
Frame Clips
illus. 8
Completed tent with rainfly. Note the 2 guy
lines on each end and 4 main guylines.
Side pole
Side pole
End
guylines
End guylines
4 Main guylines attach to
fabric loops on rainfly.
Frame ties located on
under side of rainfly.
illus. 9
Stake out tent with adjustable guylines. Slide
the disc up the rope to tighten guyline.
illus. 7 Insert rainfly pole through
pole sleeve on underside of rainfly.
PRINTED IN CHINA Rev. 7/04
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
• Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage nylon
material and/or cause it to become discolored.
WARNING: KEEPALL FLAMEAND HEAT SOURCES
AWAY FROMTHISTENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous
contact with any flame source.The application of any foreign substance
to the tent fabric may render the flame-resistant properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
Grommets for rainfly poles