Comfort Zone CZPH10R Series User manual

Save These Instructions
www.comfortzoneproducts.com
Features:
• Powerful Carbon Fiber Heating Element
• Automatic Timer Setting
• Full Function Remote with Three Heat Settings
• Silent Operation
• IP34 Waterproof and Corrosion Resistant
• 3-Prong Grounded Plug
Specifications:
• 1,500W (5,120 BTU)
• 120V AC, 60Hz, 12.5A
CZPH10R Series
Outdoor / Indoor
Electric Patio Heater
with Remote Control

2
2
READ & SAVE THESE
INSTRUCTIONS
GENERAL SAFETY INFORMATION:
Read all instructions before attempting to operate this unit. Keep
the assembly instructions for future reference. Keep the original
packaging for use when storing the heater during extended
periods of non-use.
INTENDED USE:
Electric utility heaters are designed to meet a variety of heating
requirements. This product is intended for indoor and outdoor
domestic use only; not for commercial use. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. This heater must be plugged
in to a 120V AC, 15 Amp (or larger) circuit. Do not plug anything
additional into the same circuit. If you have any questions
whether your wiring is adequate, consult a qualied electrician.
Risk of re, overheating, malfunction, property damage, injury or
even death may result if not adhered to.
When indoors, use your heater only with a working smoke
detector located in the vicinity of your heater.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word “WARNING”to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result
in injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of electric shock, re, or injury to
persons, including the following precautions:
• This heater will get hot when in use. Do not touch hot surfaces.
• CAUTION: Some parts of this product can become very hot
and cause burns.
• Do not move the unit when in use. Wait until the heater is
completely cool before moving and check that it has been
unplugged from the power supply.
• Keep combustible material such as furniture, papers, clothes,
curtains, bedding cloths, papers, trees, leaves, dry grass and
bushes at least 3 ft (0.9 m) from the front of the heater and
away from the sides and rear.
• The heater must be a minimum of 6 ft (1.8 m) away from the
ground and a minimum of 1.5 ft (0.5 m) away from the ceiling
of a building or overhanging items.
• Never install your heater on a combustible surface. Do not
mount on plastic or vinyl.
• The heater must not face with the heating element pointing
upwards towards a ceiling. The heater element must be facing
the area it is to heat.
• In order to avoid overheating, do not cover the heater. Do not
put any blankets, articles of clothing, or other ammable
material covering the heater.
• Keep children and pets a minimum of 1.5 ft away from the
heater.
• Supervision is needed when this product is used anywhere
near children. The heater is not intended for use by children
or other persons without assistance or supervision if their
physical, sensory or mental capabilities prevent them from
using it safely.
• Do not operate the heater if there are any signs of damage or
malfunction of the heater.
• Do not attempt to repair or adjust any electrical or mechanical
functions on this heater. The unit does not contain any user
serviceable parts. Only a qualied electrician should perform
servicing or repairs.
• In case the power cord is damaged call Customer Service.
• Do not handle the heating element with bare hands. If it is
inadvertently touched, remove nger marks with a soft cloth
and methylated spirits or alcohol, otherwise the marks will burn
into the element causing premature heater failure.
• Do not replace or attempt to replace the infrared heating
element in this product.
• This product is suitable for indoor and outdoor use. This heater
is not intended for use in bathrooms, laundry rooms, or other
similar indoor areas. Never locate heater where it could fall into
a bathtub, swimming pool, or other water container.
• Do not touch the plug with wet or damp hands or feet.
• Do not run the power cable under carpeting. Do not cover the
power cable with rugs, runner, or similar coverings. Arrange
the power cable away from foot trafc and where it will not be
tripped over.
• Do not wind the power cable around the heater.
• Do not insert or allow foreign objects to enter any ventilation or
opening on the heater, as this may result in electric shock, re,
or damage to the heater.
• To prevent a possible re, do not block the air vents.
• A heater has hot and arcing or sparking parts inside. Do not
use in areas where gasoline, paint, explosive and/or ammable
liquids are used or stored. Keep unit away from heated
surfaces and open ames.
• Where possible, avoid the use of an extension cord as this may
overheat and cause a re.
• Always ensure the heater is plugged into a suitable socket, one
that is tested for outdoor use.
• To disconnect heater, tum controls to OFF, then remove plug
from socket. Do not unplug by pulling on the power cord.
• Always unplug the unit and ensure the unit is completely cold
before moving, cleaning or storing.
• This heater is intended for domestic use only. For commercial
use, please consult an electrician.
• The use of attachments on the heater is not recommended.
• Check exterior walls for areas of damage before installing the
heater.
• Always use on a dry, suitably strong, stable, at and level
surface.
• Check exterior walls for communication and electrical cables
and pipelines. Should any service lines be present in the
immediate vicinity do not install your heater, nd an alternative
location to install this product.
• This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when
occupied by people or pets not capable of leaving a room on
their own, unless constant supervision is provided.

3
3
WARNING: This heater has a voltage rating of 120 volts. The cord
has a 3-prong grounding-type plug (A) which ts the 3-slot grounded
receptacle (A2). DO NOT remove the grounding prong (A1) if only a
2-slot receptacle (B) is available.
For connecting 3-prong grounding-type plug to 2-slot receptacle, use
an ADAPTER (C). The grounding lug (C1) extending from the adapter
must be connected to a permanent ground with the Metal Screw (D)
such as a properly grounded outlet box (E).
The adapter should not be used if a 3-slot grounded receptacle is
available.
DO NOT DEFEAT THE SAFETY PURPOSE OF EITHER
A GROUNDED PRONG OR A GROUNDED LUG.
(A) (A2) (B)
(A1)
(C)
(D)
(E)
(C1)
Adapter is not included
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
CAUTION: PREVENT LECTRICAL SHOCK
This product has a three prong grounded plug that must be
inserted into a matching properly grounded outlet to reduce
the risk of electrical shock. Do not attempt to defeat this safety
feature.
DO NOT operate any heater with a damaged cord or plug or
after heater malfunctions, has been dropped or damaged in any
manner. Do not operate heater with a broken heating element
or ceramic cone or any visual imperfections. Disconnect power
before servicing. For repairs covered under warranty, see
warranty statement. For all other repairs contact Comfort Zone®
Customer Service by telephone or mail for information and
assistance.
PET OWNERS NOTE
The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans,
it is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion
coatings burn off.
HEATER INSTALLATION
ATTENTION!
• The heater must only be operated in a horizontal position with max. ±
15° slope. For safety, do not mount your heater in a vertical or diagonal
position. Never install your heater on a combustible surface.
DO NOT mount on plastic or vinyl.
• The distance of your heater from the ground should be a minimum of
6 ft (1.8 m).
• The distance of your heater from the ceiling should be a minimum of
1.5 ft (0.5 m).
WARNING: For your safety, do not attempt to alter this heater in any way.
Do not attempt to perform repairs on your heater. Consult a professional
electrician.
WALL MOUNTING
1. Please make sure your heater is unplugged from the outlet before
installing.
2. Your heater includes 4 brackets, fasteners and screws to be used to
mount your heater to the wall. There are 4 square fasteners pre-mounted
into the slot on the back
of the heater. Fasten two
brackets to the fasteners
pre-mounted in the slot.
We recommend the
brackets be positioned at
least 6" from each other.
Line up the fasteners to
the holes in the bracket
and screw the bracket to
the fasteners.
5. Screw the wall brackets to
the brackets on the heater,
using a nut to tighten.
Be sure to adjust the heater
angle before tightening the
screws so that the heat is
directed to the area being
heated.
CORRECTINCORRECT INCORRECT
3. For safety, the unit should
be mounted at least 6 ft
above the ground. It should
be installed at least 18"
away from the ceiling or
roof, and should be at least
18" from a wall or structure
to the left and the right of
the mounted heater.
4. Using the screws provided, screw the
remaining two brackets into the wall so
the protruding parts are parallel to each
other. These parts will attach to the
brackets on the back of the heater.
6 ft.
18 in.
18 in.

4
4
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser against defects in
quality or workmanship for a period of one year from the date of original
purchase. If this unit fails because of a manufacturing defect within
30 days of purchase, return the unit, with your receipt, to the retailer. After
30 days, but within the warranty period, if the unit was purchased within
the continental United States, return it, freight prepaid, to World and Main
for repair or replacement. If the unit was purchased outside the continental
United States, return the unit to the place of purchase. This warranty does
not cover damage caused by misuse, abuse, overheating or alteration.
Repairs made by anyone other than World and Main are not covered in
this warranty. World and Main will not be held liable for any losses due
to neglectful operation. All implied warranties, including the warranties of
merchantability and of tness of purpose, if applicable, are hereby limited in
duration to the period of one year from the date of original retail purchase.
Some states do not allow limitations on how long an implied warranty lasts,
so the above limitations may not apply to you. Incidental or consequential
damages arising from a breach of either express or implied warranties are
hereby disclaimed and excluded. Some states do not allow the exclusion
of limitation of incidental or consequential damages, so this limitation or
exclusion may not apply to you. Upon the expiration of this warranty all such
liability will terminate. No other warranties are expressed or implied.
This warranty gives you specic legal rights, and you may also have other
rights which vary from state to state. No informal dispute settlement
mechanisms are available. This limited warranty is given in lieu of all other
warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
CARE AND MAINTENANCE
Regular and careful cleaning and maintenance will help your
heater operate longer and more efciently.
CAUTION – Before cleaning or servicing the heater, be sure to
disconnect power cord and allow the heater to cool completely.
Remove the wire grille using a screwdriver. Check the reector and
Infrared lament for dirt and dust once a month. If dirt or dust is present,
clean according to instructions.
Clean the OUTSIDE SURFACE with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners. DO NOT IMMERSE THE HEATER IN WATER.
Allow heater to dry completely before use. Any other service should be
performed by a authorized service representative.
Do not use harsh chemical (gasoline, benzene, paint thinner, harsh cleaners,
etc.) or abrasive cleaners as they will damage
the heater. NEVER USE ALCOHOL OR SOLVENTS.
REPAIR: DO NOT OPERATE THE HEATER WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE HEATER IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Unplug the power cord. Inspect the wire grille, heater body, power cord and
plug periodically. In case of damage or defect, consult an electrician.
WARNING: DO NOT attempt to repair or adjust any electrical or mechanical
functions on this heater. The unit does not contain any user serviceable
parts. ANY MAINTENANCE OR REPAIRS - INCLUDING REPLACING
THE HEATING ELEMENT - SHOULD BE CARRIED OUT BY A QUALIFIED
ELECTRICIAN ONLY.
STORAGE: Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage. Store heater in
a cool, dry place.
Rev. 06/15/22
NOTE: Following each command, the heater will emit
a buzzing noise to let the user know the command has
been set.
OPERATING INSTRUCTIONS
The functions of the heater may be controlled via the
buttons on your remote control or the electronic control
panel on the heater.
Plug in the heater. Turn ON the MASTER POWER
SWITCH on the rear of the heater.
SETTING THE TIMER:
The heater can be programmed to turn
off using a timer setting. The timer can be
set to turn off at 1-hour intervals up to
24 hours.
Using manual controls, after you have set
the heat output level (P1, P2 or P3), press
the Timer button to set the timer. Using
remote control, press the Timer button.
• The control panel will show 0.1 which
means the timer is set for 1 hour.
• 0.2 means the timer is set for 2 hours,
etc.
• Keep pressing the timer button until
the control panel reads the amount
of hours you would like to set the
timer for.
CLEANING:
1. Remove the wire grille
using a screwdriver.
2. The reector and lament
should be cleaned with
a soft cloth, a smooth
brush, cool or dry air. The cloth may be damp but not too wet. Do not use
chemical cleaning agents on the reector or infrared lament.
3. Replace the wire grille.
REMOTE CONTROL:
• Function Button: On/Off/Standby.
• After turning on the heater, you can
choose low heating, medium or high
setting by pushing the corresponding
wattage button.
• Press the timer button to adjust and
set the time.
Digital Screen
Heat Modes
Manual
Operation
Remote Control
Operation
PO =
STANDBY MODE
Press ON/OFF
Button
Press ON/OFF
Button
P1 =
LOW HEAT
500W
Press ON/OFF
Button
SECOND time
Press the
Button
Labeled 500W
P2 =
MEDIUM HEAT
1,000W
Press ON/OFF
Button
THIRD time
Press the
Button
Labeled 1,000W
P3 =
HIGH HEAT
1,500W
Press ON/OFF
Button
FORTH time
Press the
Button
Labeled 1,500W
On/Off
Low
High
Medium
Timer
Power Level
Indicator
ON/OFF and
Power Mode
Button
Timer
Button
LED Display