Commander M7100N User manual

to hold a call.
press a
press again to return to the b
first call on hold. Check the display for
confirmation or additional information.
Note: If you have difficulty selecting a line
on your M7100N Keystation, ask your
System Administrator to check your
keystation’s programming. Your keystation
must be assigned to use an exchange line
or line pool.
about the memory key.
The memory key can store a telephone
number or feature code to give you one
touch dialling or feature activation. You can
change the memory key by programming it
with a new number or feature code.
Remember: Press to check
memory or line key.
programming memory keys.
External Autodial
if you are on a call or a line with dial tone, a
press or .
press b
dial the external number c
press to store the number d
label your new key e
Internal Autodial
if you are on a call or a line with dial tone, a
press or .
press b
dial the extension number c
label your new key d
Features
if you are on a call or a line with dial tone, a
press or .
press b
press and the feature code c
label your new key d
Erasing memory keys
If you are on a call or a line with dial tone, a
press or .
press b
press to erase the key c
Note: M7100N is equivalent to Economy
Keystation referred to in some documentation.
Commander Australia Limited
Sales 1300 138 833 Service 1300 138 899
www.commander.com
S/I 742/213
04/02 ®Commander is the registered trademark of Commander Australia Limited ACN 082 384 343.
M7100N
Keystation User Guide
memory key

features.
hold key 01
dial pad 02
volume control 03
feature key starts or ends a feature 04
release key cancels active calls 05
memory key is programmable to store a feature or to automatically dial 06
an internal or external number.
display shows the time, date and call information; guides you while using 07
Commander features; tilts for easy viewing.
using key inquiry.
Check what is programmed on your
memory key.
release all calls or lines with dial tone a
press b
press the key that you want to check c
read the display d
press when finished e
adjusting display contrast.
press a
press to for the level you want; b
the higher the number the higher the level.
selecting a ring type
and volume level.
press a
press , , or , to hear the b
different ring types.
while the keystation is ringing, c
press to adjust the volume level.
press to store the ring d
adjusting the handset or
keystation speaker volume.
press when using the handset a
or the speaker.
answering calls.
When your keystation rings, lift your handset.
You are immediately connected to the call.
making external calls.
Depending upon the dialling mode
programmed for your keystation, you may be
able to dial your call before lifting the handset.
pick up the handset a
dial (your system’s exchange line b
access code or a line pool access code).
dial the external telephone number c
making internal calls.
pick up the handset a
dial the internal number b
Note: Extension numbers and the
exchange line access code are supplied by
your System Administrator.
making or answering a
second call.
The M7100N Keystation allows you to have
two calls active at the same time. You can
switch between calls using .
To answer a second call while on
another call
press to put the first call on hold. a
The second call automatically comes onto
the line.
To hold a call and make a second call
press to put the first call on hold a
dial the telephone number for the b
second call.
To return to the first call
press again to return to the first a
call on hold. The second call is automatically
put on hold.
01 02 03 04 05 06 07