CommScope CMAX-OUS-UW43-i53 User manual

M0149ALB_InstI nstr _CM A X-OUS-UW43-i53
Technical Support:
http://w ww .com mscope.com /wi su pp or t
INSTALLATION INSTRUCTION FOR
CMAX-OUS-UW43-i53
Installation Mode 1
Installation Steps
1) Cut a hole on ceiling with the diameter shown in the left picture.
2) Remove the retaining nut from the back of the antenna.
3) Feed the pigtail of the antenna through the hole.
4) Re-install the retaining nut so that it is close-fitting to the ceiling.
Note: Cable min. bending radius: 40mm

M0149ALB_InstI nstr _CM A X-OUS-UW43-i53
Technical Support:
http://w ww .com mscope.com /wi su pp or t
Installation Mode 2
Installation Steps
1) Drill two holes into the ceiling per the pattern of holes which are
shown in the right chart above.
2) Insert the plastic plug into the holes.
3) Remove the retaining nut from the back of the antenna.
4) Fix the antenna to the ceiling by using the tapping screws
(ST4.2X25) and plastic plug (∅6X25mm).
© Copyr ig ht 2020 Com m Scope, Inc.
All r ig hts r eser ved.
All inform ation contained in this manual has been r evised thoroug hly. Yet CommScope accepts no liability for any om issions or
faults.
Com m Scope reser ves the right to chang e all hardware and softwar e char acteristics without notice.
Nam es of products menti oned her ein are used for identification purposes only and may be tr adem ar ks and / or reg istered
tr adem ar ks of their respective companies.
No par ts of this publication may be reproduced, stor ed i n a retr ieval system, transmitted in any form or by any means,
electronical, mechanical photocopying , r ecor ding or otherwise, without prior w ritten permission of the publisher .
Com m Scope, 04-May-2020