CommScope MST-4 User manual

1
MST-4
INSTALLATION INSTRUCTION
MST-4
The Multiport Service Terminal (MST) is supplied with a length of feeder
cable and incorporates hardened connector technology that is designed
to withstand the rugged outside plant environment. These hardened
connectors are factory-terminated and environmentally sealed for use in
optical drop cable deployments.
1.1 Open the terminal with a flat screw driver.
Turn 90° counterclockwise.
1 Wall mounting
1.2 Mount the terminal to the wall with the 3 screws in the kit.
2.3 Connect the 2 dust caps from terminal port and hardened
connector to keep the dust caps clean for future use.
2.2 Orientation of the connector: white dot facing upwards.
2.1 Unscrew the dust caps off both, the connector and the adapter, and
install the hardened connector (hand tighten).
2 Customer connection
Always clean the connector before inserting!
General
TC-1248-IP
Rev A, Apr 2017
www.commscope.com

MST-4
INSTALLATION INSTRUCTION
3 Close and lock the terminal.
MST-4
© 2017 CommScope, Inc. All rights reserved.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc.
This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to
CommScope products or services.
This product is covered by one or more U.S. patents or their foreign equivalents. For patents, see:
www.commscope.com/ProductPatent/ProductPatent.aspx.
To find out more about CommScope® products, visit us on the
web at www.commscope.com
For technical assistance, customer service, or to report any
missing/damaged parts, visit us at:
http://www.commscope.com/SupportCenter